
• Short press the Speed Up Button once to turn
the device to level one, press Speed Up Button
again to turn the device speed up. The corresponding
speed will be displayed on the Speed Level Display.
What includes in the package
Mebak Chic Percussive Massage Gun X1
Interchangeable Applicators X8
Charging Cable X1
User Manual X1
Carrying Protective Case X1
3.Operating Instructions
• Power device on by long pressing the Power Switch
. Power device off by long pressing the Power
Switch .
• To save power, the device will automatically turn off
after 3 minutes in the standby state without any
operation.
• When the Battery Volume Display pulsates, stop
using the device and charge the device.
• Rotated the applicator slightly pull it out and push it
in to change the applicators.
Charging
• Fully charge the device for 3.5 hours before first use.
• In charging, the Battery Level Display pulsates to
show battery level and indicate charging status. The
Battery Level Display stops pulsating and stays at
99, it indicates that the battery is fully charged.
• The Battery Volume Display has 99, 80, 60, 40, 20
gears display.
• The average charging time is 3 hours.
• The average run-time is 2 hours depending on speed
level and pressure applied during use.
• Battery may be recharged at any time and at any
battery level.
• It is not recommended to fully deplete the battery to
20%.
• It cannot be used when the device is in charge.
4.Warranty
If within six months from the date of purchase, this
product fails due to a defect in material or
workmanship, Mebak will repair or replace the product,
or necessary components, free of charge.
THIS WARRANTY EXCLUDES:
1.damage caused by accident, abuse, mishandling;
2.units subjected to unauthorized repair;
3.units not used in accordance with Mebak’s care
instructions;
4.damage exceeding the cost of the product;
5.deterioration of the delivered product resulting from
abnormal storage and/or safeguarding conditions on
the client’s premises, and
6.failure to provide the dated proof of purchase.
• Short press the Power Switch to turn the device
to standby. The Speed Level Display shows “00”
which is on standby.