Medic Therapeutics UVC DISINFECTION LAMP User manual
UVC DISINFECTION LAMP
User Manual
In order to maximize the proper use of this product,
please read this manual carefully prior to operation.
LIMITED LIFETIME WARRANTY
Your Medic Therapeutics UVC Disinfection Lamp is backed by a limited
lifetime manufacturer’s warranty. Medic Therapeutics will repair or
replace your device at any time should it fail due to a defect in material or
workmanship, subject to the certain limitations.
This limited warranty does not cover any damage that results from
unauthorized or improper use, service, or repair. Further, it does not cover
damage caused by accident, impact, negligence, or normal wear and tear.
Should you discover your Medic Therapeutics UVC Disinfection Lamp is
not functioning properly, please send your device to our repair center for
evaluation. If your product cannot be repaired or serviced, we will reserve
the right to change it for a similar or newer model.
Please note that a flat rate of $35.00 will be charged to cover a service
evaluation fee and return shipping of your device. All warranty claims must
be accompanied by a copy of your proof of purchase from an authorized
retailer. Please send your device, proof of purchase, and a check or money
order in the amount of $35.00 made out to Medic Therapeutics to:
Address:
Medic Therapeutics Service Center
3069 Taft Street
Hollywood, FL 33009
Contact:
ATTENTION
The ultraviolet lamp must be used when NO ONE is present, to avoid the
harm of direct exposure to the UVC light. Do NOT expose your eyes or skin
to the UVC light.
PRODUCT FEATURES
Metal housing: Anti-oxidation Metal Base
Simple Operation: 3 Disinfection Timers
Wireless Remote Control Operation: Operates through the Wall
No Ozone / With Ozone Operation: High-Purity Quartz Lamp
PRECAUTIONS FOR USE
1. During the use of this product, the surface of the ultraviolet lamp should
be kept clean. If there is dust or oil on the surface of the lamp, it should
be wiped in time to avoid affecting the sterilization effect.
2. When cleaning indoor air with ultraviolet lamps, the room should be
kept clean and dry to reduce dust and water vapor. When the indoor
temperature is lower than 20C° or higher than 40C°, the irradiation
time should be extended accordingly.
3. The ultraviolet lamp must be used when no one is around. Do not look
directly at the ultraviolet light source and do not expose your skin to it.
4. This UVC lamp should be used accordingly with the approximation of
1w/m. This product is suitable for the disinfection and sterilization of
rooms within 36-60 m. If the objects and garments are being sterilized at
a close range, the sterilization time should not exceed 15 minutes.
5. If there is artwork, calligraphy or paintings in the sterilized space that
require shading, please cover them with a cloth or paper during use.
6. After the use of the sterilizing lamp, it should be stored well to avoid
damage and personal injury caused by the improper use of the lamp.
REMOTE CONTROL INSTRUCTION
INSTRUCTIONS FOR USE
Online Switch + Remote Control Timing + Human Body
Detection Safety Design
1. First plug in the lamp to a power source and then turn on the online
switch on the remote and walk away.
2. Press the ON/OFF button on the remote control.
3. Select the corresponding disinfection time (15 min /30 min /60 min), and
the power indicator will flash at the same time as the corresponding time
indicator.
4. After pressing the corresponding time on the remote control, the lamp 10
second delay will be start. When the person walks into the lamp’s sensor
range of 1.5m, the lamp will turn off; the lamp will then restart within 10
seconds after the person has walked away and continue to operate until
the scheduled disinfection time has been completed.
ON/OFF 15 min time switch
60 min time switch30 min time switch
Other Medic Therapeutics Accessories manuals
