2321-0036 Kawasaki Vulcan 900 Classic Fats/Slims Mounting Kit - 06
MOUNTING INSTRUCTIONS
Read and follow these directions carefully.
During installation, make certain that when turning the
forks, there can be no interference with wiring or cables
AND, that the windshield can not hit the gas tank,
through the windshield's full range of adjustment.
This is a detachable windshield, ALWAYS make sure the
Locking Mechanism is Fully Engaged after installing the
windshield!
The improper installation of this kit and related compo-
nents could result in serious injury or death.
IMPORTANT CARE AND CLEANING INSTRUCTIONS
Memphis Shades Windshields and Lowers are made of
Lucite® acrylic, and will last for years with proper care.
Clean your windshield with plenty of soapy water — mild
dishwashing liquid is best — and a soft cotton cloth. Use your
bare hand to feel and dislodge bugs, or cover with a wet soapy
towel and let it soak. Don't use paper towels and don't scrape
with anything. Small scratches can be removed with NOVUS
# 2.
NEVER use any glass cleaning products, petroleum based
chemicals, or cleaning agents with ammonia, bleach or any
other harsh chemicals. This includes (but not limited to)
RainX, brake fluid, acetone, paint thinner, benzene and
gasoline. "If it hurts your nose, it will hurt the plastic."
Glass cleansing agents will cause severe damage
NOTE: At certain times of the day the Sunlight can reflect
off the curvature of a windshield and cause extreme heat
build-up on motorcycle instruments and instrument panel.
Take care when parking. Park facing the sun, place an opaque
object over the instruments or adjust the windshield to avoid
reflections.
First Bolt
Third
Bolt
Figure 1
7. Install the windshield by placing the lower slots into the
lower mounting bushings. Slip the upper slots into the upper
mounting bushings and gently but firmly seat the slots into
place.
Lock the locking mechanism into place.
(see figure 3)
8. Loosen the upper Allen bracket mounting bolts and re-
tighten.
9. Adjust the height, angle and alignment of the windshield
and tighten ALL bolts.
Note: This is a detachable windshield, ALWAYS make
sure the Locking Mechanism is Fully Engaged after in-
stalling the windshield! (see figure 3)
MEM8962 08-18-08
Additional tools required that are not included in this kit.
7/16" or 11mm Wrench, 12mm and 14mm deep well sockets
and ratchet.
1. Cover gas tank and front fender with towels to avoid
damage during installation.
2. Install the two mounting plates onto the windshield, using
the bottom and third bolt up. Leave the nylon washers off.
The small tab goes to the bottom, big one at the top. Tabs
point out towards the edge of the Windshield. (see fig. 1)
3. Remove and retain the two nuts that hold the Headlight to
the Lower Triple Tree. Place a protective cloth over the Turn
Signal Bar. Lift the Headlight and allow it to hang over the
Turn Signal Bar. (see figure 2)
4. Remove and retain the two nuts that hold the Handlebar
Risers to the upper Triple Tree. Pull the Wire Loom Bracket
away from the Riser Bolts. Slip the upper bracket on to the
bolts followed by the wire loom. Re-install and tighten the
Riser Nuts. (See Figure 2)
5. Loosen the Allen bolts on upper bracket and slip the left
and right side bracket into the upper bracket and loosely
tighten. “To be tightened later, see step 8”
6. Re-install the Headlight through the lower holes in the left
and right side bracket and through the lower triple tree. Re-
install and tighten Headlight Bolts.
Figure 2
Headlight
Upper
Bracket
