Memphis Beale Street BGSS26 User manual

Contents
Page
Clearance to Combustible Materials
2
Physical Setup Instructions
3-8
Wi-Fi Setup Instructions
9
Wiring Diagram 10-11
MODEL NUMBER: BGSS26
001
Revision 1.0

FRONT VIEW
Below are some guidelines to ensure safe
operation of your Beale Street Grill
•The grill is to be supported by the casters provided.
•Grill casters are to be locked while the grill is in use or
while the grill is hot.
•It is recommended that the grill be placed on a non-
combustible surface.
•Operating the grill under a combustible ceiling or
overhang is NOT recommended.
•Maintain the minimum clearance to combustible
materials specified below.
A MAJOR CAUSE OF FIRES IS
FAILURE TO MAINTAIN
REQUIRED CLEARANCES (AIR
SPACES) TO COMBUSTIBLE
MATERIALS. IT IS OF THE
UTMOST IMPORTANCE THAT
THIS PRODUCT BE INSTALLED
ONLY IN ACCORDANCE WITH
THESE INSTRUCTIONS
CLEARANCE TO COMBUSTIBLE MATERIALS
SIDE VIEW
YOUR BEALE STREET GRILL MUST MAINTAIN THE SPECIFIED CLEARANCE TO
COMBUSTIBLE MATERIALS WHILE OPERATING THE GRILL OR WHILE THE GRILL IS HOT!
002

BOM # Part Name Qty.
1Upper Grate 1
2Cabinet Front Bracket 1
3Caster and Hardware Kit 1
4Casters 4
5Cabinet Left Side 1
6Cabinet Right Side 1
7Cabinet Door Left 1
8Cabinet Door Right 1
9Cabinet Bottom 1
10 Cabinet Back 1
11 Shelf Front Left 1
12 Shelf Body Left 1
13 Shelf Front Right 1
BOM # Part Name Qty.
H1 M5 x 12 Phillips Screw 14
H2 M6 x 15 Phillips Screw 46
H3 Tool Holder 6
H4 Door Bottom Pivot 2
Hardware Kit
BOM # Part Name Qty.
14 Shelf Body Right 1
15 Grease Tray 2
16 Flavorizer 1
17 Main Grates 4
18 Power Cord Wrap 1
19 WiFi Antenna 1
Bill of Materials
H1
H2
H3
H4
Required Tools : Phillips Screw Driver and Cut Resistant Gloves
USE CAUTION DURING ASSEMBLY. METAL EDGES MAY BE SHARP.
003

Unboxing Remove packaging materials and set aside BOM items for use later.
Cabinet Assembly
Open caster and hardware box (#3). Set aside power cord wrap (#18) for later use.
Attach 4x casters (#4) to cabinet bottom (#9) using 4x M6 Phillips Screws (H2) per caster.
! Remove plastic protective lm from all parts before continuing. !
After grill is used, this lm will melt and is impossible to remove cleanly.
004

Cabinet Assembly Continued
Assemble cabinet sides and back using 6x M6 Phillips Screws (H2).
Attach cabinet front bracket to sides using 4x M5 Phillips Screws (H1).
Screw Door Bottom Pivots (H4) into cabinet
bottom (#9), unthreaded side up.
Secure the cabinet walls to the cabinet base
using 8x M6 Phillips Screws (H2).
005