Microlab FC362 User manual

Before using, pleaseread the manualcarefully
MULTIMEDIA ACOUSTICS SYSTEM
All other brand and product names are trademarks of their respective holders.Actual contents may differ slightly from those shown in print.All
specifications and designs are subjected to changes without any prior notice.
No.:80-fc362-97-0001-02
FC362
User's Manual
80-fc362-97-0001-02 2008 0415chu
80-fc362-97-0001-01 2007 11 01 chu

1
Caution:
To reduce the riskof electric shock, do not dismantle the apparatus and do not expose the apparatus to rain or moisture.
No user-serviceable parts inside. Refer servicing to qualified personnel.
Explanation of Graphical Symbols:
The lightning flash within an equilateral triangle is intendedto alert you to the presence of uninsulated angerous
voltage within the product's enclosure that may be of sufficient magnitudeto constitute an electric shock to
persons.
The exclamation point within an equilateral triangle is intendedto alert you to the presence of important operating
and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNINGS:
1. Read Instructions All the safety and operating instructions should be read beforethe appliance is operated.
2. Retain Instructions The safety and operating instructions should be retained for futurereference.
3. Heed warnings All warnings on the appliance and in the operating instructionsshould be adhered to.
4. Follow instructions All operating and use instructions should be followed.
5. Installation Install in accordance with the manufacture's instructions.
6. Power sources This product should be operated only from the type ofpower source indicated by the marking adjacent
to the power cord entry. Ifyou are not sure of the type of power supplyto your home, consult your product dealer or local
power company.
7. Grounding or polarisation the appliance is not required to be grounded. Ensure the plug is fully inserted into the wall
outlet or extension cord receptacle to prevent blade or pin exposure.Some versions of the product are equipped with a
power cord fitted with a polarized alternating line plug ( a plug having one blade wide than the other).This plug will fit
onto the power outlet only one way. This is a safety feature. If you areunable to insert the plug fully into the outlet, try
reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Donot defeat
the safety purpose of the polarised plug. When using an extension power-supply cord or a power-supply cord other than
that supplied with the appliance, it should be fitted with the appropriate moulded-on plugs and carry safety approval
appropriate to the country of use.
8. Power cord protection Power-supply cords should be routed so that they are not likely to be walked on or pinched by
items placed on or against them, paying particular attention to cords at plugs, convenience receptacles and the point
where they exit from the appliance.
9. Overloading Do not overload wall outlets, extension cords or integral convenience receptacles, as this can result in a
risk of fire or electric shock.
10.Ventilation The product must be properly ventilated. Do not place theproduct on a bed, sofa, or other similar surface.
Do not cover the product with any items such as tablecloths,newspapers, etc.
11.Heat The product should be situated away from heat sources such as radiators, heat registers, stoves, or other
products)including amplifiers_ that produce heat. No naked flame sources, such as lighted candles, should be placed
on the apparatus.
12.Wall or ceiling mounting The product should be mounted to a wall or ceiling only as recommended by the manufacture.
13.Water and moisture To reduce the risk of fire or electric shock, do not expose the product to train, dripping, splashing
or excessive moisture such as in a sauna or bathroom. Do not use this product near water for example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool and the like.
14.Object and Liquid Entry Never push objects of any kind into this product through openings,as they may touch
dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid ofany kind on
the product. Do not place any object containing liquid on topof the product.
15.Cleaning Unplug the product from the wall outlet before cleaning. The cabinet of the subwoofer may be cleaned by
dusting with a dry cloth. If you wish to use an aerosol cleaning spray, do notspray directly on the cabinet; spray onto the
cloth. Be careful not to disturb the drive units.
16.Attachments Do not use attachments not recommended by the product manufactures, as they may cause hazards.
17.Accessories Do not place this product on an unstable cart, stand, tripod, bracket or table. The product may fall,
causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand,tripod, bracket
or table recommended by the manufacturer or sold with the product. Any mounting of the product shouldfollow the
manufacturer's instructions and should use a mounting accessory recommended by the manufacturer.
18.Moving the appliance A product and cart combination should be moved with care. Quick stops, excessive force and
uneven surfaces may cause the product and cart combination to overturn.
19.Non-use periods The power cord of the appliance should be unplugged from the outlet during lightning storms or when
Important Safety Instructions Trouble Shooting
Troubles Solution
Check if the system is powered on
Check the power plug well connected
Check if the audio source is working well
Check if the audio and speaker cables well
connected
Check if the volume at right level
One or more satellite no sound Check if the satellite cable well connected
No Bass Check if the Bass Volume at right level
Remote control not working Check if the battery in the remote control
If the problem still exists, please contact the distributor or ask for professional service
Power LED won't light up
No Sound
Sound is distorted
6
Check if the volume at lower level
80-fc362-97-0001-02 2008 0415chu
80-fc362-97-0001-01 2007 11 01 chu

2
The apparatus is left unused for a long periodof time.
20.Serving Do not attempt to service this product yourself, as openingor removing covers may expose you to dangerous
voltage or other hazards. Refer all servicing to qualified servicepersonnel.
21.Replacement parts When replacement parts are required, be sure the service technician hasused replacement parts
specified by the manufacturer or have the same characteristics asthe original part. Unauthorized substitutions may
result in fire, electric shock or other hazards.
22.Mains fuses For continued protection against fire hazard, use fuses only of thecorrect type and rating. The correct fuse
specification for each voltage range is marked on the product.
23.Do not turn up the volume while listening to asection with very low level inputs or no audio signals.If you do, the
speaker may be damaged when a peak level section issuddenly played.
24.The only means of completely disconnecting the product from thepower supply is by removing the power cord from the
wall outlet or the product. Either the wall outlet orthe power cord entry to the product must remain freelyaccessible at all
times while the apparatus is in use.
25. The socket-outlet shall be installed near the equipmentand shall be easily accessible.
Unpacking:
*Fold the carton flaps right back and invert the carton and contents.
*Lift the carton clear of the contents.
*Remove the inner packing from the product.
We suggest you retain the packing for future use.
You should find following items while unpacking:
Amplifier 1pc
Woofer 1pc
Satellite 2pcs
3.5mm-2RCA signal cable 1pc
User's manual 1pc
Unpacking the system
Specification
*Amplifier specification:
AC IN 220V- 240V~50Hz 200mA
Power output 24W+15Wx2 ( RMS THD=10% )
Frequency response 35Hz-20KHz
Sensitivity Input 340mV
Distortion <0.3%(1W 1KHz)
Separation >50 dB
S/N >75 dB
*Driver unit: (Woofer)5.25"(magnetically shielded)
(Satellite)2" x2(magnetically shielded)
*Audio input: (Input 1) 3.5mmstereo jack
(Input 2) RCAjack
*Audio output: RCAjack
*Product size(DxWxH): (Amplifier)210x77x200mm
(Woofer Speaker) 297x204x210mm
(Satellite Speaker) 80x180x260mm
Technical Information
5
Features
V12: designed by denmark famous speaker designer Peter Larsen, V12 fine cone 2 full range
speaker unit sets the industrial standard by its excellent flat response curve: 130HZ-8KHZ 1.5dB
and 100HZ-20KHZ 3dB.
2.1+1system: microlab-launched external power amplifier Hi-Fi 2.1 system is easy-use and
user-friendly. It can eliminate audio distortion caused by vibration, overheat and electromagnetic
interference. It is the best choice for those who persist in Hi-Fi sound quality.
5.25 subwoofer: 5.25 subwoofer unit made of dual Sr Magnet system blazes the trail in the use
of costly low-Q value, long-stroke program design, having the low-frequency quality of quick and
high resolution.
Full frequency: by virtue of its outstanding quality, V12 fine cone 2 full-range speaker can
provide ideal sound effect, build true 3D sound field and reproduce rich levels and details.
eAirBass:
Design for music: the ultimate aim of microlab R&D system is to inherit and carry forward the
european musical culture style. To do this, all designs must be music-oriented and sourced from
music and art. Having microlab, you can enjoy european musical taste.
Departing from traditional bass technology, eAirBass creates no distortion when
enhancing bass. With brandnew airflow passage design, it delivers clearer sound with an extended
frequency range. The use of electronic control technology enables a precise bass signal selection for
enhanced bass delivery and crystal clear high notes reproduction. Moreover the sychronous phase
control technology guarantees accurate bass delivery, providing an effective solution for slow
frequency response. With Microlab eAirBass, distortion-free, lifelike and rigoroso deep bass is
possible.
80-fc362-97-0001-02 2008 0415chu
80-fc362-97-0001-01 2007 11 01 chu

FUSE
L R
RLS.W.
INPUT 1
INPUT 2
T400mAL250V
AUDIO INPUT
AUDIO OUTPUT
AC IN
*Front View of the Amplifier
*Back View of the Amplifier
Function Instruction
BASS
TREBLE
VOLUME
PHONE
POWER
1
2
3
4
56
1
2
3
5
1.POWER INDICATOR
Turn onthe power,the power indicator is lightened
2.BASS CONTROL
Turn thebass control anti-clockwise to minimum,
adjusting the basscontrol to your demanding level
3.TREBLE CONTROL
Turn thetreble control anti-clockwise to minimum,
adjusting the treblecontrol to your demanding level
4.VOLUME CONTROL
Adjust thespeaker system's volume, turn the volume
control anti-clockwise tominimum, adjusting the
volume control toyour demanding level
5.PHONE JACK
Youcan connect theyour headphone with 3.5mm
stereo plug tothis jack
6. POWER(ON/OFF)
Press this keydown to switchthe system ON,
Press this keyup to placethe system OFF.
4
1.INPUT 1
Stereo signal input jack
2.INPUT 2
2.1 channel (2 RCA) signal inputjack
3.AUDIO OUTPUT
2.1 channel (3 RCA) signal outputjack
4.AC IN
5.FUSE
3
Amplifier
FUSE
L R
RLS.W.
INPUT 1
INPUT 2
T400mAL250V
AUDIO INPUT
AUDIO OUTPUT
AC IN
R L
Subwoofer
To VCD DVD ,etc
1. Connect the satellite speaker cables to the L & R audio output sockets on the back of the amplifier,
then put the left channel satellite speaker on the left and the right satellite on the right.
2. Connect the cable of the woofer speaker to the back of the Amplifier audio output S.W. socket.
3. While connecting to VCD/DVD, etc, please use the double RCA ends audio cable. Connect one end
of the audio cable to the output socket on the VCD /DVD, the other end to the "L" & "R" of Input 2
on the back of the amplifier.
4. While connecting to sound card(CD MP3,etc), please use the audio cable with double 3.5mm
stereo plugs. Connect one end of the audio cable to the audio output sockets on the sound card
(CD MP3,etc), then other end to the Input 1 socket on the back of amplifier.
5. Check the connection and make sure every cable is correctly connected, then connect power plug
to the right AC outlet. The shape of the plug and power outlet depends on the country of use.
*When you connect the headpones to your speaker, you can only hear the sound in your headpones.
System Connection
To MP4 MP3 CD etc
4
80-fc362-97-0001-02 2008 0415chu
80-fc362-97-0001-01 2007 11 01 chu