Miele H 6180 BP User manual

Installation Instructions
H 6180 BP, H 6280 BP en - CA
Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.

Electrical connection
78
CAUTION:
Before servicing, disconnect the
power supply by either removing the
fuse, shutting off the power main or
manually "tripping" the circuit
breaker.
Installation, repair and maintenance
work must be performed by a Miele
authorized service technician. Work
by unqualified persons could be
dangerous and may void the
warranty.
Before connecting the appliance to
the power supply, make sure that the
voltage and frequency listed on the
data plate correspond with the
household electrical supply. This
data must correspond to prevent
machine damage. Consult an
electrician if in doubt.
Only operate the appliance after it
has been installed into cabinetry.
The power cable plug must be
inserted into a suitable outlet that
has been installed and grounded in
compliance with all applicable local
regulations.
WARNING: THIS APPLIANCE MUST
BE GROUNDED
Installer: Please pass these
instructions on to the customer.
Electrical connection
The oven is equipped with a power
cord approx. 5' 6" (1.7 m) in length with
a NEMA 14-30 P plug ready for
connection to the power supply:
– 120/208 V, 30 A, 60 Hz
or
– 120/240 V, 30 A, 60 Hz
The voltage can be adjusted (see
"Settings - ").
SAVE THESE INSTRUCTIONS FOR
THE ELECTRICAL INSPECTOR'S
USE.
(NEMA 14-30P, L1, L2, N, G, 30 amp
208/240 VAC)

Installation diagrams
79
Appliance and cut-out dimensions
Miele ovens can be installed flush or proud. Discuss your installation
requirements with your architect, designer and installer.
Undercounter installation
BB
23 3/4" (603 mm)
16 15/16" (430 mm)
28 7/16"
(722 mm)
26 3/8"
(670 mm)
27 13/16"
(707 mm)
7/8" (22*/23** mm)
29 13/16"
(757 mm)
28 5/8"
(727 mm)
28 1/4"
(718 mm)
28 1/2"
(724 mm)
24"
(610 mm)
4"
(100 mm)
AA
Cut-out (4" x 28" / 100 mm x 720 mm) in the bottom of the cabinet for power
cord and ventilation
Power cord with plug
*Oven with glass front
** Oven with metal front
Depending on the model, the oven front may differ from the one shown the
drawing. Current specifications can be found on the Miele website.

Installation diagrams
80
Installation into a tall cabinet
BB
23 3/4" (603 mm)
16 15/16" (430 mm)
28 7/16"
(722 mm)
26 3/8"
(670 mm)
27 13/16"
(707 mm)
7/8" (22*/23** mm)
29 13/16"
(757 mm)
28 5/8"
(727 mm)
28 1/4"
(718 mm)
28 1/2"
(724 mm)
24"
(610 mm)
AA 4"
(100 mm)
Cut-out (4" x 28" / 100 mm x 720 mm) in the bottom of the cabinet for power
cord and ventilation
Power cord with plug
*Oven with glass front
** Oven with metal front
Depending on the model, the oven front may differ from the one shown the
drawing. Current specifications can be found on the Miele website.
! Please note: For flush mount installations, please take the depth and location of the electrical utility box
into consideration prior to planning your design. For more information please contact our Customer Care
Centre. !

Installing the oven
81
The oven must not be operated
until it has been properly installed
within cabinetry.
The oven must have an adequate
supply of cool air for proper
operation. The required air must not
be heated excessively by other heat
sources, e.g. wood burning stove.
Observe the following when
installing:
Build into cabinetry with no back
wall.
Make sure that the shelf that the
appliance sits on does not touch the
wall.
Do not install insulation strops on the
side walls of the cabinet housing.
Before installation
Before connecting the oven to the
power supply, first disconnect the
power supply from the oven isolator
switch.
Installing the oven
Connect the power cord to the
electrical supply.
Do not carry the oven by the door
handle. The door can be damaged.
Use the handles on each side of the
oven to carry it.
It is recommended that you remove
the door before installing the
appliance (see "Cleaning and Care -
Removing the door") and all oven
accessories from the cavity. This will
make for easier installation into the
niche and will not tempt you to use
the handle to carry it.
Remove the side handles, if any.
Push the oven into the cabinetry and
align it.
Open the door (if it was not removed
previously).
Use the supplied screws to secure
the oven to the side walls of the
cabinetry through the holes in the
trim.
Reinstall the door, if necessary (see
"Cleaning and care - Installing the
door").

9 Independence Way
Princeton, NJ 08540
Phone:
Fax:
www.mieleusa.com
U.S.A.
Miele, Inc.
National Headquarters
Please have the model and serial number
of your appliance available before
contacting Technical Service.
Canada
Importer
Miele Limited
Headquarters and Miele Centre
800-843-7231
609-419-9898
609-419-4298
Technical Service & Support
Nationwide
Phone:
Fax:
T
[email protected]
161 Four Valley Drive
Vaughan, ON L4K 4V8
www.miele.ca
800-999-1360
888-586-8056
Customer Care Centre
Phone:
[email protected]
800-565-6435
905-532-2272
Germany
Manufacturer
Miele & Cie. KG
Carl-Miele-Straße 29
33332 Gütersloh
82

M.-Nr. 09 786 760 / 03en – US, CA
H6180BP; H6280BP
