18 19ENGLISH
l) Hold the power tool by insulated gripping surfaces
only, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord.
m) Position the cord clear of the spinning accessory.
n) Never lay the power tool down until the accessory
has come to a complete stop.
o) Do not run the power tool while carrying it at your
side.
p) Regularly clean the power tool’s air vents.
q) Do not operate the power tool near fl ammable materi-
als.
r) Do not use accessories that require liquid coolants.
Further safety instructions for abrasive cutting-off
operations
Kickback and related warnings
a) Maintain a fi rm grip on the power tool and position
your body and arm to allow you to resist kickback
forces. Always use auxiliary handle, if provided, for
maximum control over kickback or torque reaction
during start-up.
b) Never place your hand near the rotating accessory.
c) Do not position your body in line with the rotating
wheel.
d) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
e) Do not attach a saw chain, woodcarving blade,
segmented diamond wheel with a peripheral gap greater
than 10 mm or toothed saw blade.
f) Do not “jam” the wheel or apply excessive pressure.
Do not attempt to make an excessive depth of cut.
g) When wheel is binding or when interrupting a cut for
any reason, switch off the power tool and hold the pow-
er tool motionless until the wheel comes to a complete
stop. Never attempt to remove the wheel from the cut
while the wheel is in motion otherwise kickback may oc-
cur.
h) Do not restart the cutting operation in the workpiece.
Let the wheel reach full speed and carefully re-enter the
cut.
i) Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kickback.
j) Use extra caution when making a “pocket cut” into
existing walls or other blind areas.
WALL CHASER & DUST EXTRACTOR TOOL SYSTEM
WORKPLACE
WORK ORGANIZATION
TRANSPORT, HANDLING AND STORAGE
ENGLISH
TECHNICAL DATA WCE 30 (110 V) WCE 30
WALL CHASER
Noise/Vibration Information
Wear ear protectors!
WARNING! Read all safety warnings and all
instructions.
Save all warnings and instructions for future reference.
CUT-OFF MACHINE SAFETY WARNINGS
a) The guard provided with the tool must be securely
attached to the power tool and positioned for maximum
safety, so the least amount of wheel is exposed towards
the operator. Position yourself and bystanders away
from the plane of the rotating wheel.
b) Use only bonded reinforced or diamond cut-off
wheels for your power tool.
c) The rated speed of the accessory must be at least
equal to the maximum speed marked on the power tool.
d) Wheels must be used only for recommended applica-
tions. For example: do not grind with the side of cut-off
wheel.
e) Always use undamaged wheel fl anges that are of
correct diameter for your selected wheel.
f) Do not use worn down reinforced wheels from larger
power tools.
g) The outside diameter and the thickness of your
accessory must be within the capacity rating of your
power tool.
h) The arbour size of wheels and fl anges must properly
fi t the spindle of the power tool.
i) Do not use damaged wheels. Before each use,
inspect the wheels for chips and cracks. If power tool
or wheel is dropped, inspect for damage or install an
undamaged wheel. After inspecting and installing the
wheel, position yourself and bystanders away from
the plane of the rotating wheel and run the power tool
at maximum no load speed for one minute.
j) Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety
glasses. As appropriate, wear dust mask, hearing
protectors, gloves and shop apron capable of stopping
small abrasive or workpiece fragments.
k) Keep bystanders a safe distance away from work
area. Anyone entering the work area must wear per-
sonal protective equipment.
WARNING
