Minerva AV-6010 User manual

Remove bracket if it's on chair bottom.
Attach the footrest to the chair
front using the four remaining
bolts and lock washers.
3
Seat cushion and
headrest are removable.
May need to be placed
into locations as shown
once all steps of assembly
are complete.
Seat cushion
2
Then attach seat to the assembled
bracket and hydraulic.
bracket
Attach bracket to piston.
bolt
1A
Noble All
Purpose Chair
SKU: AV-6010
Part Qty.
PARTS LIST*
Description
Assembly Instructions
B1
Chair top
Bracket
Bolt
1
1
1
1Footrest bar
Base and hydraulic
Bolt + washer + lock washer
8
1C
Headrest
D
E
F
G
H
1
! ALWAYS KEEP HYDRAULIC BASE UPRIGHT. THE HYDRAULIC
SHOULD NOT BE STORED OR TURNED UPSIDE-DOWN !
The bracket must be bolted to the hydraulic before the chair can be safely
attached. The bracket may already come bolted on the hydraulic, but if not,
it must be removed from the chair by removing the four bolts.
Now remove the bolt from the piston, place the bracket on the piston,
and screw the bolt back into the piston through the bracket.

Enjoy your new chair!
Remember to always keep the
hydraulic upright. Also be sure
not to stand solely on the footrest.
It is good to pump the hydraulic
to full height and back down several
times right after assembly to prime
the hydraulic fluid. This will keep the
pump smooth and responsive.
Note that short quick pumping is more
effective than pressing the lever all the
way down each time.
If you have any questions or problems
during assembly please call our
customer service at 1.888.332.0123
Thanks for choosing Minerva!
4
Assembly now complete.