Minerva 3378 User manual

26
Double-sided Icon Styling Station
Model #3378
PARTS LIST**
Components (Label - Description)
3 - Top cabinet section
4 - Mirror panel
1 - Base
2 - Bottom cabinet section
Qty. Sketch Part Description
Assembly Instructions
Short Allen bolts
Long Allen bolts
Medium Allen bolts
Short bolt anchors
Handles
Washers
Appliance rings
Handle screws 24
10
12
32
4
4
4
Large Allen wrench (included)
Small Allen wrench (Included)
Phillips-head screwdriver (Not included)
Tools required:
**Open all drawers and boxes to check
for parts before beginning assembly.
A
B
C
D
E
F
G
H

3
2
1
3) Turn wrench to tighten
1) Insert and
hold steady
2) Insert bolt into
anchor
1) Remove all the drawers from the top cabinet section (3) by pressing the black release tabs in the
glides (one up, one down) and pulling. It is not necessary to remove the doors from the upper
section. Lay drawers out in proper order for replacement.
2) Set the top cabinet section (3) on top of the bottom cabinet section (2), aligning the 4 small holes
in each.
3) Drop the 4 short bolt anchors (H) into the holes in the bottom of the top cabinet section (3) and
secure by screwing in the 4 short Allen bolts (D) with washers (G) upward through both cabinet
sections into the anchors. Use the small Allen wrench to hold the anchors in place while
tightening the bolts.
3 - Mounting the top cabinet section
x4
x4
x4
x4
x4
1 - Mounting bottom cabinet section
1) Remove all the drawers from the bottom cabinet
section (2) by pressing the black release tabs in
the glides (one up, one down) and pulling.
Lay drawers out in proper order for replacement.
2) Set the bottom cabinet section (2) on top of the
base (1), aligning the 4 small holes in each.
3) Secure the bottom cabinet section (2) to the
base (1) using the 4 medium Allen bolts (E)
and 4 washers (G) as shown.
2
1
D
B
DD
DD
BB
BB
D
A
E
A
A
DD
A
A
D
D
E
E
E
E

1) For shipping, the drawer handles (I) are attached to the insides of the drawer faces. Using a
Phillips-head screwdriver, remove the 2 screws (J) in each and reattach the handles on the
front of the drawers.
2) Drop the metal appliance rings (K) into the holes in the appliance drawers.
3) Slide the drawers back into their respective glides.
4 - Mounting the mirror panels
x24
x10
x12
2
x24
x24
4
3
1
4
5 - Replacing the drawers
D
C
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
DCCD
F
G
H
F
G
G
G
G
H
H
H
H
H
H
1) Rotate the front mirror panel (4) such that the holes in the back of the panel are aligned with
the holes in the front faces of the bottom and top cabinet sections (2, 3).
2) Attach the Shelf to the mirror panel using a long allen bolt (F). Do this for both sides.
3) Anchor the front mirror panel to the cabinets using the long Allen bolts (F) and washers (H).
3) Repeat steps 1 and 2 for the rear mirror panel (4), using the same configuration of bolts and
washers.