Minka Group minkaAire ORB F623L User manual

ORB

2019

F623L

INSTALLING THE LIGHT KIT PLATE
INSTALLING THE GLASS SHADE

12.7
Glass Shade
Light kit plate
4

5
6
7
8
9
.10

5 6 78
9
10

11
13
12

11
12
13
13

13

14 15
Step 1: Insert the blade through the slot on the
center housing. Secure the blade with three blade
screws and three fiber washer provided.(Fig 14)
Step 2: Repeat for the remaining three blades.(Fig.15)
CENTER HOUSING
BLADE
FIBER WASHER
BLADE SCREW

16
Step 1: Remove one of three screws from the mounting ring on the fan
motor assembly and loosen,but do not remove, the other two screws.
Step 2 : Place the key holes from the light kit plate over the two screws
previously loosened from the mounting ring. Turn the light kit plate until
it locks in place at the narrow section of the key holes. Secure by tightening
the two screws previously loosened and the one screw previously removed.
INSTALLING THE LIGHT KIT PLATE
MOUNTING PLATE
LIGHT KIT PLATE LIGHT KIT PLATE
SCREW

17
Step 2 .Remove one of three screws from the light kit plate and loosen,but
do not remove, the other two screws.(Fig.17)
Step 3 . Place the key holes from 16W LED assembly over the two screws
previously loosened from the light kit plate. Turn the 16W LED assembly
until it locks in place at the narrow section of the key holes. Secure by tightening
the two screws previously loosened and the one screw previously removed.(Fig.17)
LIGHT KIT PLATE
16W LED ASSEMBLY
WIRE CONNECTION
PLUGS
LED ASSEMBLY SCREW

Raise the glass shade up against light kit plate and secure it to fan by
turning it clockwise until snug. DO NOT OVERTIGHTEN.(Fig 18)
INSTALLING THE GLASS SHADE
18
LIGHT KIT PLATE
GLASS SHADE

19
19
19