8Joint Upper Pillar to the
installed Metal Plates.
Make sure the square holes
on Upper Pillar align the
same.
Tighten M6x12 Bolt rmly.
Lower Pillar
Upper
Pillar
M6x12 Bolt
9Install Cradle Base to your
favorite hole.
Hook both ends to the
square holes then slide
down to x.
Cradle Base
10
Push Lock Lever toward
the pillar to lock Cradle
Base position.
To change Cradle Base
position, pull back Lock
Lever then pull out the
cradle.
11
Lock Lever
Use screwdriver
to release Lock
Lever. Do NOT do
with your nger,
otherwise your nail
may be damaged.
Assemble Bike Cradle.
Angle Adjust
Plate
Cradle Bar
Cradle Hook (universal)
M6x14 Bolt
M6x20 Bolt
Flat & Spring
Washers
Set Angle Adjust Plate as the long
hole is set downward.
Cradle Hook must be installed
from back of Cradle Bar to
prevent scratching problem to
your bike frame.
12
Bike cradle is angle adjustable to
t to your bike's top-tube angle.
Loosen the lower bolt (long hole
side) to adjust. After that tighten
the bolt rmly.
The bike should be as horizontal
as possible.
Set and lean GravityStand to the
wall.
The pillar must be set parallel to
the wall to keep best stability.
Put the top-tube of your bike on
Cradle Hooks gently.
Do NOT apply any paper
or thin plate under Legs to
prevent slippage accident.
13
Each position and angle of Cradle
Hook is also adjustable.
IMPORTANT NOTES
• Gravity Stand is only for normal
2-wheel bikes. Do not use for any
other purposes.
• Gravity Stand will not supported
nor xed. Be careful not to hit the
stand when you passing nearby.
• Gravity Stand is designed to keep
enough stability even having heavy
shocks. But we highly recommend
you to x the stand to the wall with
the supplied strap.
• Remove any sand and dust from
the area Leg touches to prevent
slippage problem.
• Check every bolt regularly and
tighten rmly with proper tool if you
nd any loose.
• Minoura offers 1-year limited
warranty from the date of your
purchase. Any problem caused
by manufacturer's defect and
wrong workmanship will be
covered by this program. But any
trouble caused by user's misuse,
unapproved modication, natural
calamity and every problem
happened during shipment will
NOT be covered by Minoura.
For more detail, please refer the
attached "Warranty Program
Instruction" card.
FOR MORE INFORMATION
If you have any quetion, contact the
shop where you purchased or your
local distributor rst.
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305
Phone +81-584-27-3131
Fax +81-584-27-7505
Web www.minoura.jp
MINOURA NORTH AMERICA
Made in Japan
- Page 2 -
