11
11
1
!
RS-1200 instructions manual
Thank you for purchasing the Minoura RS-1200 bicycle repair stand.
The RS-1200 is a stand for basic bike maintenance and repair work. t supports your bike at a height that allows
easy access. The bike is supported at 3 positions; the bottom bracket shell, the down-tube and the seat-tube.
The angle of the down-tube support arm and the seat-tube support hook position are adjustable to insure a perfect
fit to your frame. The frame is also foldable for easy storage when it is not in use.
Please read this instructions carefully before use.
HOW TO ASSEMBLE RS-1200HOW TO ASSEMBLE RS-1200
HOW TO ASSEMBLE RS-1200HOW TO ASSEMBLE RS-1200
HOW TO ASSEMBLE RS-1200
11
11
1nstall the step-bar tubes to the frame and the leg. (see Fig. A)
(Fig. A)
22
22
2nstall the down-tube support arm to the main frame, then screw
the knob bolt to the hole on the arm bracket.
33
33
3Open the seat-tube stay and insert the seat-tube support hook
and plug in the end-cap.
MINOURA JAPAN MINOURA NORTH AMERICA
1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN (for North American residents only)
Phone: +81-584-27-3131 / ax: +81-584-27-7505 1996 East Avenue, Hayward, CA 94541 U.S.A.
Email:
minour
[email protected] /
http://www
.minoura.jp
ax:
1-510-538-5899
/
Email:
MinHelp@A
T
T
global.net
Seat-tube
Support Hook
Seat-tube
Support Arm
Down-tube
Support
Front Wheel
Support Stay
Support
Arm Angle
Adjust Knob
Frame
Step-bar
Leg
HOW TO MOUNT YOUR BIKE ON RS-1200HOW TO MOUNT YOUR BIKE ON RS-1200
HOW TO MOUNT YOUR BIKE ON RS-1200HOW TO MOUNT YOUR BIKE ON RS-1200
HOW TO MOUNT YOUR BIKE ON RS-1200
22
22
2Place the BB shell onto the BB support,
lean the bike backward until the seat-tube
touches the hook, then adjust the down-
tube support arm angle by turning the knob
bolt.
(Fig. B)
Use RS-1200 ONLY on a flat and stable
floor in order to prevent accidents.
TIPSTIPS
TIPSTIPS
TIPS
If the brake or shifter cable is routed
under or beside the down-tube and is
pinched between the frame and the
bracket, use the supplied adapter.
Open the seat-tube support arm fully and
set the left side crank arm towards the front
wheel..
