MJM 418-OR-3TW User manual

WARNING NOT SECURING ALL PARTS PROPERLY CAN CREATE A SERIOUS SAFETY HAZARD.
NOTE: A PHILLIPS SCREWDRIVER OR A CORDLESS HAND DRILL IS REQUIRED TO
TIGHTEN/SECURE ALL SCREWS.
IDENTIFY ALL COMPONENTS TO START ASSEMBLY
PARTS INCLUDED FOR WALKER
PARTIALLY ASSEMBLED FRAME.
4 CASTERS (2 WITH BRAKE & 2 NON BRAKE
SIDE OUTRIGGERS WITH ANTI--TIPS--2
SIDE RAILS--- 2 MAKE UP THE ARM SECTIONS
SPRING LOADED FLAT GATE---1 IS CONNECTED TO ONE SIDE RAIL
PVC BACK --1
MESH SLING-- 1
SEAT CUSHION--1
SAFETY BELT-- 1
CLAMP LOCKS FOR ADJUSTABLE HEIGHTS-- 4PLACED ON BOTTOM FRAME
REINFORCEMENT RINGS -- 4 ATTACHED TO BOTTOM FRAME IN CORNERS
STEP 2
STEP 1
NOTE: A PHILLIPS SCREWDRIVER OR A CORDLESS HAND DRILL IS REQUIRED TO TIGHTEN/SECURE ALL SCREWS.
STEP 5
STEP 3
STEP 4
STEP 6
STEP 7-1
REV. B Date: 17-02-11 Page 1 of 2
MJM International Corporation 1-800-270-6199 Fax: [phone]
www.mjminternational.com [email protected]m
MJM INTERNATIONAL CORPORATION
418-OR-3TW
REMOVE SCREWS FROM REINFORCEMENT
RINGS
INSERT CASTERS --PLACE BRAKE WHEELS
ON THE REAR OF THE WALKER
SECURE CASTERS WITH SCREWS PROVIDED
USING PILOT HOLE AS REFERENCE
INSERT OUTRIGGERS ON THE SIDE OF THE
BOTTOM FRAME BY MATCHING COLOR CODED
DOTS AND SECURE USING SCREWS PROVIDED
USING PILOT HOLES AS REFERENCE
REMOVE SCREWS FROM AREA BY SEAT
SECTION
INSERT SIDE RAILS BY MATCHING COLOR CODED
DOTS.

418-OR-3TW COMPLETELY ASSEMBLED
STEP 9
WARNING NOT SECURING ALL PARTS PROPERLY CAN CREATE A SERIOUS SAFETY HAZARD.
NOTE: A PHILLIPS SCREWDRIVER OR A CORDLESS HAND DRILL IS REQUIRED TO
TIGHTEN/SECURE ALL SCREWS.
STEP 7-2
STEP 10
STEP 11
STEP 7-3
STEP 8
REV. C Date: 17-02-11 Page 2 of 2
NOTE: CASTERS/CLAMP LOCKING SYSTEM MUST BE CHECKED AND SECURED PRIOR TO USING 418-OR-3TW
MJM INTERNATIONAL CORPORATION
418-OR-3TW
MJM International Corporation 1-800-270-6199 Fax: [phone]
www.mjminternational.com [email protected]
INSERT MESH SLING WITH PVC BACK TOWARDS
SEAT SECTION ON TOP OF SIDE RAILS,SECURE
USING SCREWS PROVIDED AND PILOT HOLES AS
REFERENCE.
SECURE SIDE RAILS USING SCREWS
PROVIDED AND PILOT HOLES AS
REFERENCE
NOTE: CLAMP LOCKS CAN BE REMOVED TO ADJUST THE HEIGHTS ON THE WALKER.
NOTE: SECURE SAFETY BELT ON THE FRONT GATE AND SECURE SEAT CUSHION WITH VELCRO
STRAPS
ADJUST MESH SLING AS NEEDED
INSERT SIDE RAILS BY MATCHING COLOR CODED
DOTS .
SECURE FLAT GATE ON FRONT SIDE RAIL
USING PILOT HOLE PROVIDED