Mocka Kids Steel Wagon User manual

Kids Steel Wagon
1
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Hardware Supplied
x11
B
ACDE
F G HI
x4 x4
x1
x2
x1 x1
8 mm
35 mm
x1
long screw
x8
short screw
35 mm
nut
medium
screw
round ball
washer end cap
spanner
circular swivel support
brace
J
x2
For added safety make regular checks to ensure all
screws and nuts are tight and secure.
Warning:Small parts are used to assemble the Kids Steel Wagon
and should only be assembled by an adult. Keep all assembly parts away
from small children.
Suitable for ages 12 months +
Phillips screwdriver
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
Kids Steel Wagon
2
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
First connect the long handle with round black ball (F). Connect
this to the front axle by threading long screw (C) through the holes in
the axle and round ball, and fastening with nut (B). Tighten nut with
spanner (I).
Using 3 x small screws (A) and nuts (B), attach circular swivel through
the corresponding holes to the axle frame. Hold screws in place with
screwdriver and tighten nuts (B) with spanner (I).
x1
F
x3
A
B
C
BAA
B
B

3
3
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Lower wagon tray onto the axles. Slide on rear support braces (J) to
back axle. Attach rear axle to the wagon tray using two medium screws
(G) and 2x nuts (B) and tighten from underneath using the spanner (I).
Attach the rear support braces and the circular swivel to the wagon tray
using 5x small screws (A) and nuts (B). Tighten from underneath using
the spanner (I).
Kids Steel Wagon
4
A
A
A
A
A
J
J
G
G
x5
B

5
4
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
Kids Steel Wagon
6
To attach the wheels first slide four washers (D) on to the axles. Then
slide on all four wheels before pressing on the end caps (E).
Secure end caps (E) by tapping with a hammer to ensure correct fitting.
Securely tighten all nuts (B) before use. You’re done, enjoy!
x4
E
E
E
D
D
E
D