Modern Flames MF-PRO-WTC User manual

©2019
www.modernfl ames.com
Please dispose of properly.
V1
Wireless Wall Mounted Touch Control
MF-PRO-WTC
NEW PART # TH-WTC/LP
PAIRING THE WALL CONTROLL
1. With the fireplace ON press and hold the ON/OFF button for
about 3 seconds until you hear the buzzer sound twice and the power
indicators begin to flash. (power indicators located top right of viewing
area)
2. Within 5 seconds on the wall control press the ON/OFF(power)
button repeatedly until the buzzer sounds again and the indicators flash
acknowledging that it has paired. You may also hear another buzzer and
the pair is now completed.
-Pairing must be done within 5 seconds or the fireplace will time out of
pairing mode.
-To clear any paired remotes from the unit locate then press and hold
the reset button for 3 seconds. You should hear a buzzer letting you
know the codes have been cleared so you can now pair a new remote or
wall control. (The reset is located next to the manual controls and can be
pressed with a paper clip.)

Installing Optional Wall Mounted Touch Control
1. Locate 2-gang low voltage bracket within 20 feet of fi replace. Install
according to manufacturer’s instructions.
2. Remove glass face (attached with magnets) from metal bracket.
3. Attach the metal bracket to the low voltage bracket with the included
screws.
4. Insert batteries (2 AAA) and replace the glass face.
5. Pair wall control to fireplace.
This will cycle the machine on and off . Upon cycling
power on, the machine will return to the settings it
had when it was cycled off .
If the fi replace is on, this button will act as a reset
and bring all colors back to the default Modern
Flames orange/yellow.
This will cycle the heater between high, low and off .
This will allow you to use the Up or Down arrows to
set a time (indicated by the display screen). Times
will be ½h, 1h or 3h. Upon reaching this time the
machine will power off .
All zones of the fi replace will cycle through various
demo modes.- color gradients/fade, color jumps
This is a zone setting. Touching this button will
allow you to change the color and brightness of the
fl ame by using the RGB wheel and brightness
slider.
This is a zone setting that controls the color and
brightness of the ember bed.
This is a zone setting that controls the color and
brightness of the downlight.
Pressing the sync button will change all the colors
of the fi replace) Flame, Ember Bed and Downlight)
to match the current color of the fl ame setting.
Pressing the Up or Down arrows will start the
thermostat setting. Set to the desired temperature
and the unit will automatically confi rm within a few
seconds.
Power
Reset
Heat
Fade/Demo
Sync
Flame
Ember
Bed
Downlight
Timer
Arrows