modway EEI -2226 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI –2226/2227 CHAIR
Hardware:
Component:
A Bolt M6x45mm x 4
C Flat Washer M6 x 4
1
Chair Body x1 2 Bottom Base x1
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
B Spring Washer M6 x 4
D Allen Wrench x 1
2
1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –2226/2227 CHAIR
STEP 1:
STEP 2:
Please put Chair Body (1) upside down on a carpeted or padded area.
Place Bottom Base (2) to bottom of the Chair Body (1) as shown.
Attach by using 4 pieces of Bolt (A), 4 pieces of Spring Washer (B) and 4 pieces of Flat Washer (C).
Use Allen Wrench (D) to tighten all Bolts (A) clockwise until secure.
Ax4 Cx4 Bx4 Dx1 Hardware & Tool required
B
C
D
1
2
Assembly is completed. The chair is ready to use now!
Carefully turn over the chair.
A