modway EEI-2122 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI –2122/2123 OFFICE CHAIR
Hardware:
Component:
1 Bolt M8x20mm x4
3 Allen Wrench x1
A Chair Body x1 B Control Mechanism x1
Thank you for purchasing the MODWAY OFFICE CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
A
C Caster x5
D F
C
Cylinder x1 Decoration Cover x1
C
C
C C
E
D
B
E Chair Base x1
F
2 Flat Washer M8 x4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –2122/2123 OFFICE CHAIR
STEP 1:
STEP 2:
Please put Chair Base (E) upside down on a carpeted or padded surface.
Insert 1pc of Castor (C) into the Chair Base (E) as shown by hand.
Repeat the same steps for the remaining 4pcs of Castor (C).
D
F
E
Flip the assembled Chair Base (E) with Castors (C) on the floor.
Insert Decoration Cover (F) into the assembled Chair Base (E) as shown.
Insert the bottom end of Cylinder (D) into the assembled Decoration Cover (F) and Chair Base (E) as shown.
C
C
C
C
C
E
C
C
C
C
C

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI –2122/2123 OFFICE CHAIR
D
B
1x4pcs 3x1pc 2x4pcs
STEP 3:
Hardware & Tool required
STEP 4:
Carefully turn over the assembled Chair Body (A) and Control Mechanism (B).
Line up the hole on the bottom of the assembled Control Mechanism (B) with the top end of Cylinder (D), drop the assembled
Chair Body (A) and Control Mechanism (B) onto the Cylinder (D) naturally. Rotate a few times to test security.
Please put the Chair Body (A) upside down on the carton.
Attach Control Mechanism (B) into the bottom of Chair Body (A) by using 4 pieces of Bolt (1) with 4 pieces of Flat Washer (2)
as shown.
Use Allen Wrench (3) to tighten all Bolts (1) clockwise until secure.
Assembly is complete. The office chair is ready to be enjoyed now!
B
A
D