modway EEI-2148 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI –2148 CHAIR
Hardware:
Component:
A Bolt x 8
D Allen Wrench x 1
1 Chair Body x1 2 Leg x4
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
1
2
2
B
Flat Washer x 8
C
Spring Washer x 8
2
2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –2148 CHAIR
Ax8 Bx8 Cx8 Dx1
STEP 1:
STEP 2:
Assembly is completed. The chair is ready to enjoy now!
Please find the package of Legs (2) and hardware on the top of the seat.
Then put the Chair Body (1) upside down on a carpeted or padded area by two adults to make the corners fully visible .
Position one of Legs (2) at one of the four wooden corners.
Insert 2 pieces of Spring Washer (B) and 2 pieces of Flat Washer (C) into 2 pieces of Bolts (A) as shown.
Then insert the assembled 2 pieces of Bolts (A) into the corner to connect the Leg (2).
Use Allen Wrench (C) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the other three Legs (2).
Hardware & Tool required
1
Carefully turn over the assembled Chair Body (1) as shown.
A
B
C
D
C
B
A
A
B
C A
B
C
1
2
2
2 2