modway EEI-2709 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI–2709 SIDE TABLE
Hardware:
Component:
A Bolt M6x70mm x 4
1
Table Top x1
Thank you for purchasing the MODWAY SIDE TABLE!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the side table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
B Allen Wrench M4 x 1
2
2
1 2 Side Frame x2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI–2709 SIDE TABLE
STEP 1:
STEP 2:
Please put 1 piece of Side Frame (2) on a carpeted or padded area.
Insert the tenon on Table Top (1) into the rabbet on the Side Frame (2) as shown.
Carefully position the assembled Table Top (1) and Side Frame (2) as shown.
Insert the tenon on Table op (1) into the rabbet on the other Side Frame (2).
2
1
2
1
2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI–2709 SIDE TABLE
STEP 3:
Assembly is complete. Your side table is ready to be used now!
Insert 4 pieces of Bolt (A) into pre-drilled holes on Table Top (1) through the pre-drilled holes on Side Frames (2).
Use Allen Wrench (B) to tighten all the Bolts (A) clockwise until secure.
Hardware & Tool required
Ax4 Bx1
Carefully position the assembled side table to the desired location.
STEP 4:
A
A
A
2
2
1
B
A