modway EEI-2674 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI –2674
Hardware:
Component:
A Bolt M6x31.5mm x 4
B
1
Body x1 2 Base x1
C Allen Wrench M4 x 1
1
Plastic Washer x 8
2
Thank you for purchasing the MODWAY Bar stool！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the stool, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
BAR STOOL
Stool
Stool

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –2674
STEP 1:
STEP 2:
Ax4 Bx8 Cx1 Hardware & Tool required
1
C
Please put Stool Body (1) upside down on a carpeted or padded area.
Positon Stool Base (2) to the bottom of Stool Body (1).
Insert 4 pieces of Bolt (B) into the holes on bottom of Stool Body (1) through the holes on 8 pieces of Plastic washer (B)
and Stool Base (2) as shown.
Use Allen Wrench (C) to tighten all Bolts (A) clockwise until secure.
A
B
B
1
2
Note: Make sure to position 1 piece of Plastic Washer (B)
on the bottom of leg tube, and 1 piece of Plastic Washer (B)
on the top of leg tube for each Bolt (A).
Carefully turn over the assembled stool.
Assembly is complete. Your stool is ready to be use now!
BAR STOOL