modway EEI-2677 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2677 TABLE
Hardware:
Component:
A
1 Table Top x1
Thank you for purchasing the MODWAY TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
1
2 Table Leg x3
2
Screw M4x100mm x12
2
2
PHILLIPS HEAD SCREW DRIVER
NOT PROVIDED

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2677 TABLE
STEP 1:
Hardware & Tool required
STEP 2:
Assembly is complete. Your table is ready to be used now!
Carefully turn over the assembled table.
Please put the Table Top (1) upside down on a carpeted or padded area.
Position 1 piece of Table Leg (2) to the bottom of Table Top (1) as shown.
Secure 4 pieces of Screw (A) into the hole on bottom of Table Top (1) through the hole on Table Leg (2).
Repeat the same steps for the remaining Table Legs (2).
Use Phillips Head Screw Driver (Not Provided) to tighten Screw (A) clockwise until secure.
Ax12 PHILLIPS HEAD SCREW DRIVER
NOT PROVIDED
1
A
2
2
2
A A
A
A
A
A
A
A A A A