modway EEI-2707 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI–2707 SOFA
Hardware:
Component:
A Bolt M6x70mm x 6
6
Sofa Seat x1
Thank you for purchasing the MODWAY SOFA!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the sofa, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
2 Left Frame x1 3 Right Frame x1
B Allen Wrench M4 x 1
4
1
1
2
Top Rail x1
6 Back Cushion x1 7 Seat Cushion x1
4
3
5
5
7
5 Back Rail x2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI–2707 SOFA
STEP 1:
STEP 2:
Carefully position Right Frame (3) to the assembled Sofa Seat (1), Left Frame (2), Top Rail (4) and Back Rails (5) as shown.
Insert the tenon on Sofa Seat (1), Top Rail (4) and Back Rails (5) into the rabbet on Right Frame (3).
1
4
3
4
2
1
5 5
2
5 5
Please put Left Frame (2) on a carpeted or padded area.
Insert the tenon on Sofa Seat (1) into the rabbet on Left Frame (2) at first.
Then insert the tenon on Top Rail (4) and Back Rails (5) into the rabbet on Left Frame (2) as shown.

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI–2707 SOFA
STEP 3:
Assembly is complete. Your sofa is ready to be used now!
Carefully turn over the assembled Sofa Seat (1), Left Frame (2), Right Frame (3), Top Rail (4) and Back Rails (5).
Insert 3 pieces of Bolt (A) into the pre-drilled holes on Sofa Seat (1), Top Rail (4) and Back Rail (5) through the bottom
pre-drilled holes on Left Frame (2).
Use Allen Wrench (B) to tighten Bolts (A) clockwise until secure.
Repeat the same steps for Right Frame (3).
Hardware & Tool required
Ax6 Bx1
Carefully position the assembled sofa to the desired location.
Put Back Cushion (6) and Seat Cushion (7) into the assembled sofa as shown.
STEP 4:
A
A
A
B
A
2
1
3
4
5
5
A
A
6
7