modway EEI-2146 User manual

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 1 of 2
EEI –2146/2147 CHAIR
Hardware:
Component:
A Bolt M8x70mm x 8
D Allen Wrench x 1
1 Chair Body x1 3 Back Leg x2
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair , we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
3
2
2
3
B Spring Washer x 8
C Flat Washer x 8
2 Front Leg x2
1

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 2 of 2
EEI –2146/2147 CHAIR
Ax8 Bx8 Cx8 Dx1
STEP 1:
STEP 2:
Assembly is completed. The chair is ready to enjoy now!
Please find the package of Legs (2&3) and hardware on the top of the seat.
Then put the Chair Body (1) upside down on a carpeted or padded area by two adults to
Make the corners fully visible .
Position one of Back Legs (3) at one of the four wooden corners.
Insert 2 pieces of Spring Washer (
((
(B)
))
), Flat Washer (C) into 2 pieces of Bolts (
((
(A)
))
) as shown.
Then insert assembled 2 pieces of Bolts (A) into the corner to connect one piece of the Back Leg (3).
Use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the remaining one piece of Back Leg (3) and two pieces of Front Legs (2).
Carefully turn over the chair .
Hardware & Tool required
1
2
2
3 3
A A
A A
A
C
B
D
1