modway EEI-2813 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI –2813/2814 BAR STOOL
Hardware:
Components:
A Bolt M6x14mm x 4
D Allen Wrench M4 x 1
1 Barstool Back x1 2 Barstool Base x1
B Nut M6 x 4
C Wrench M6 x 1
Thank you for purchasing the MODWAY BAR STOOL！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the Barstool, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
2
1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –2813/2814 BAR STOOL
Ax4 Bx4 Cx1 Dx1
STEP 1:
STEP 2:
Put Barstool Base (2) on a carpeted or padded area.
Attach Barstool Base (2) to Barstool Back (1) by using 4 pieces of Bolt (A) and 4 pieces of Nut (B) as shown.
Use Wrench (C) and Allen Wrench (D) to tighten the Bolts (A) and Nut (B) until secure.
Carefully put the assembled barstool to the place you desired.
Hardware & Tool required
2
2
Assembly is complete. Your barstool is ready to be used now!
1
B
A
A
A
A
B
B
C
D
C
B
A
D