modway EEI-3421-NAT-WHI User manual

EEI-3421-NAT-WHI ARMCHAIR
Customer Service 908-368-1025︱www.modway.com Page 1 of 3
Hardware:
Component:
A Bolt M6x50mm
x 10
BAllen Wrench M5 x 1
1. Chair Back
7. Support Wooden
3. Left Frame
4. Right Frame
2. Chair Seat
5. Back Cushion
6. Seat Cushion
x1
x1
x1
x1
x1
x1
x2
7
3
4
1
2
5
6
7
Before you start, here are some helpful advice:
We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
Owing to the size and weight of the armchair, we recommend that it is assembled by two adults,
on a carpeted or padded area, in the room that it is intended for. Approximate assembly
time: 30 minutes.
Please do not use any tools other than those provided or recommended in these instructions.
Please do not throw away any of the packaging or instructions until you have checked all
the components and hardware and the furniture is fully assembled.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary
to tighten the components from time to time, so please save the tools that have been provided.
Please keep all pieces out of reach of small children.
1.
2.
3.
4.
5.
6.
Thank you for purchasing the MODWAY ARMCHAIR.

EEI-3421-NAT-WHI
Customer Service 908-368-1025︱www.modway.com Page 2 of 3
STEP 1:
STEP 2:
3
2
2
7
7
1
3
7
7
3
1 2
4
Insert Support Wooden (7) one by one through the drilling hole.
Insert the tenon on Chair Seat (2) into the rabbet on Left Frame (3) at first.
Please put Left Frame (3) on a carpeted or padded area.
Insert Chair Back (1) through the drilling hole.
Carefully position Right Frame (4) to the assembled Chair Back (1), Chair Seat (2) and Left Frame (3) as shown.
Insert the tenon on Chair Back (1) and Chair Seat (2) into the rabbet on Right Frame (4).
1
1
2
2
3
3
5
5
3
3
ARMCHAIR

EEI-3421-NAT-WHI
Customer Service 908-368-1025︱www.modway.com Page 3 of 3
STEP 3:
STEP 4:
Put Back Cushion (5) and Seat Cushion (6) into the assembled chair as shown.
Carefully position the assembled chair to the desired location.
Ax10 Bx1
Hardware & Tool required
5
6
A
B
Carefully turn over the assembled Chair Back (1), Chair Seat (2), Left Frame (3) and Right Frame (4).
Insert 5 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1), Chair Seat (2), Support Wooden (7)
through the top pre-drilled holes on Left Frame (3).
Repeat the same steps for Right Frame (4).
Assembly is complete. Your armchair is ready to be used now!
3
4
1
2
7
ARMCHAIR