modway EEI-4671 User manual

EEI-4671, 4672 CHAIR
Customer Service 609-256-9000︱www.modway.com Page 1of 2
Thank you for purchasing the MODWAY CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x30mm x4
Flat Washer x4
1. Chair Body x1 2. Chair Base x1
A.
D. Allen Wrench x1
C.
Spring Washer x4
B.

EEI-4671, 4672 CHAIR
Customer Service 609-256-9000︱www.modway.com Page 2of 2
STEP 1:
1. Remove the hardware bag from the Chair Base (2) package.
2. Please put Chair Body (1) upside down on a carpeted or padded surface.
3. Put Chair Base (2) on the Chair Body (1) as shown.
4. Insert 4 pieces of Bolts (A) with4piecesofSpring Washers (B) and 4 pieces of Flat Washers (C) from the
pre-drilled holes on Chair Base (2) into the Chair Body (1) as shown.
(Note: the wider side is the front of the chair body, the narrower side is the back of the chair body.)
5. Use Allen Wrench (D) to tighten all Bolts (A) clockwise until secure.
STEP 2:
Carefully turn over the assembled chair.
Assembly is complete. Your chair is ready to enjoy now!