modway EEI-2268 User manual

Customer Service 609-256-9000︱www.modway.com Page 1 of 2
EEI-2268 COFFEE TABLE
Hardware:
Component:
ABolt M6x20mm x4
B
CAllen Wrench M4 x1
1 Table Top x1
Thank you for purchasing the MODWAY COFFEE TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
Bolt M6x25mm x4
2
2Leg x2

Customer Service 609-256-9000︱www.modway.com Page 2 of 2
EEI-2268 COFFEE TABLE
STEP 1:
Remove the plastic covers which pre-install in the end of the Table Top (1) by using Allen Wrench (C).
Please put 1 piece of Leg (2) and Table Top (1) upside down on a carpeted or padded area as shown.
Insert Table Top (1) into the Leg (2) as shown.
Insert 2 pieces of Bolts (B) from the pre-drilled holes on the bottom of the Table Top (1) into each side on the bottom of Leg (2).
Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Table Top (1) into each end of Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for the remaining 1 piece of Leg (2).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
STEP 2:
Assembly is completed. The table is ready to enjoy now!
Carefully position the table to your desired location.