modway EEI-1030 User manual

EEI-1030 BARSTOOL
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 1of 2
T
hank you for purchasing the MODWAY BARSTOOL .
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the barstool, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 20minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
Hardware:
A. Bolt M6x30mm x 4
B. Allen Wrench x 1
Component:
1 Seat x1 2 Base x1
1
2

EEI-1030 BARSTOOL
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 2of 2
STEP 1:
Please put Seat (1) on a carpeted or padded surface.
Attach Base (2) to the Seat (1) by using 4 pieces of Bolts (A) as shown.
Tighten Bolts (A) by using Allen Wrench (B) as shown.
Hardware & Tools required
STEP 2:
Carefully turn over the assembled unit from step 1.
Assembly is completed. Your barstool is ready to be used now!
x 4
x 1
B
A
A
B
1
2