modway Adept EEI-3061 User manual

EEI-3061 BENCH
Customer Service 908-368-1025︱www.modway.com
Page 1 of 4
Thank you for purchasing the MODWAY BENCH.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 20 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
A. Bolt M8x 65mm x 8
B. Bolt M8x 45mm x 4
C. Spring Washer x 12
D. Flat Washer x 12
E. Allen Wrench x1
Components:
1 Bench Body x1 2 Leg x 2 3 Leg stretcher x 4 4 Leg x2

EEI-3061 BENCH
Customer Service 908-368-1025︱www.modway.com
Page 2 of 4
STEP 1:
Please put Bench Body (1) on a carpeted or padded surface.
Open the zipper the bottom of the Bench Body (1) and take out the 2 pieces of Leg (2) and 4 pieces of Leg
Stretcher (3) & 2 pieces of Leg (4) and hardware from the legs box.
STEP 2:
Attach 1 piece of Leg (2) to the bottom of Bench Body (1) by using 2 pieces of Bolts (A) with 2 pieces of Spring
Washer (C) and 2 pieces of Flat Washer (D) as shown.
Tighten Bolts (A) by using Allen Wrench (E) as shown.
Hardware & Tools required

EEI-3061 BENCH
Customer Service 908-368-1025︱www.modway.com
Page 3 of 4
STEP 3:
Insert the smaller end of Leg Stretcher (3) into the hole of Leg （2）and attach the other end of Leg Stretcher
(3) to the bottom of Bench Body (1) by using 1 piece of Bolts (B) with 1 piece of Spring Washer (C) and 1 piece
of Flat Washer (D) as shown.
Hardware & Tools required
STEP 4:
Repeat the same steps for other pieces of Leg (2) & Leg Stretcher (3) and Leg (4) & Leg Stretcher (3).
Place Legs (2&4) to the right postion as shown.
Hardware & Tools required
B
x 2
A
x 6
x 4
D
x 1
E
C
x 6

EEI-3061 BENCH
Customer Service 908-368-1025︱www.modway.com
Page 4 of 4
STEP 5:
Close the zipper on the bottom of the Bench Body (1).
Carefully turn over the assembled Bench Body (1) and Legs (2) & Leg Stretcher (3) as shown.
Assembly is complete. Your Bench is ready to be used now!
1
1