MOEM 10G Series User manual

!!!Instruction!Manual!(10G!Series)!
IMPORTANT!!:
PLEASE READ COMPLETE INSTRUCTIONS BEFORE OPERATING THE LOCK
Usage for guest
When first use the default factory code is 1680
Lock:
Close the door and hold on, input 4 to 6 digit code and press
“Enter”(within 5 mins after unlocking press “Enter” to lock
directly, the old code unchanged)
Unlock:
Input guest code and press “Enter”, the door will open
automatically.
Note:
• “Cancel” can be used to delete the code in the process of
inputting;
• Press “Cancel” before input, the code will not be shown but
instead of “-“;
• Concessive 3 times error entry, the operation is frozen for
about 5 minutes.
Usage for administrator
1. Check battery capacity:
When the safe is locked press “Enter”, “BATT-H”
indicate batteries are normal, “BATT-L” indicates
batteries are insufficient , for security and normal use
please change batteries as quick as possible. The
discarded batteries should be disposed eco-friendly!
2. The following functions are carried out under
administrator mode
To enter administrator mode:
Double press “Cancel” quickly, the screen displays “SUPER”,
input current administrator code, press “Enter”.
Note: Default factory administrator code is “000000”.
To open
In the administrator mode input operation code “00”, and
press “Enter” ,the door will open automatically.
To modify administrator code:
In the administrator mode:
a. Input operation code “01”, press “Enter”, the screen
displays “NEW”;
b. Input 6 digit new administrator code, press “Enter”,
the screen displays “REPEAT”;
c. Input new code again, press “Enter”, the screen
displays “GOOD”, modification is completed.
To modify unlocking records data and time:
The data and time is used in internal control board for
unlocking record, to ensure the correction of the unlocking
record, when first use and after changing the batteries please
set the data and time.
a. Input operation code “08”, press “Enter”, the screens
shows “SET-DT”;
b. Then the screen shows the date message, the format
is “YYMMDD”, YY is year, MM is month, DD is day, for
example 2008-10-20, input 081020
c. Input date and press “Enter”;
d. The screen shows time message, the format is
“hhmmss”, hh is hour, mm is minute, ss is second
e. Input the time and press “Enter”
f. The screen shows “GOOD”.

To check the unlocking record:
A record is shown in two screens, the first screen displays
date message, the format is “YYMMDD”, YY is year, MM is
month, DD is day, the second screen shows the time message
and opening method, the format is “hhmm-x”, hh is hour, mm
is minute, x is as following:
1 - open by administrator
7 - open by CEU
8 - open by guest code
9 - open by override key
In the administrator mode:
a. Input operating code “09”, press “Enter”
b. The first screen message of the latest record is shown
At this time the key function is as followed:
2 - to previous record
8 - to next record
4 - to the first screen of a record
6 - to the second screen of a record
5 - to the latest record
C - to exit browsing record
Other key - factory reserved.
To exit administrator mode:
When the screen displays “CC--” press “Cancel”.
Forget the administrator code
a. Open the safe with mechanical key or guest code;
b. Remove the back cover of the door;
c. Press and hold “RESET” button in control board;
d. Wait for about 7 seconds until screen displays
“RESET”, release the button;
e. Install the back cover of the door, the administrator
code is restored to “000000”;
f. Please refer to Usage for administrator 2 to modify
administrator code.