Moffat TW1 Instruction and safety manual

Manual 019 Issue 001 July 2020
Toast Warmers
Operating & Service Manual

Contents
Electrical Specification
General Installation
Operation
Cleaning
1
2
3
4
page
3
3
4
5
The appliance must only be used for the purpose it was designed for
and may become unsafe if used for any other purpose. Operators
should be trained. The room where this trolley is used must be dry,
clean with temperatures between 16°C and 25°C and with a maximum
relative humidity of 60%. This unit is for indoor use only and has an IPX4
rating.
To ensure the best results from this unit please take the time to read
and follow all safety, installation and maintenance guidelines carefully
before proceeding to install. Keep this manual in a safe place for future
consultation.
These appliances are CE-marked in compliance with the relevant Low
Voltage & EMC Directives. Voltage stated on unit data plate.
Warning! Please pay attention to sections of the manual displaying this
symbol.
Warning! Do not attempt to use a hose or water jet to clean this unit. For
cleaning instructions, refer to section 15.

1: Electrical Specification
Live (L1)
L2
L3
Neutral
Earth
1 Phase Cable
Brown
X
X
Blue
Yellow & Green (Striped)
3 Phase Cable
Brown
Black
Grey
Blue
Yellow & Green (Striped)
This appliance must be earthed and damaged cables must be
replaced by a suitably qualified person!
A mains cable, type H07RN-F, conforming to code designation 60245
IEC 57, is supplied.
2: General Installation
Before installation please read the following points:
This equipment is designed to be operated by suitably qualified
persons. It is the responsibility of the Supervisor or equivalent to instruct
users, provide suitable P.P.E., show the mains isolating switch location,
and inform users that parts may become hot, causing injury if touched.
1. Remove all packaging & plastic coatings from the appliance.
2. Check for any damage.
3. Assemble all parts, including racks etc.
4. Ensure all switches and thermostat controls are in the OFF position
5. Connect the mains input plug to the socket outlet.
6. Turn on and check the unit is functioning correctly.
3

3: Operation
Model
TW1
TW2
Weight
(kg)
7
10
Dimensions
L X W X H (mm)
331 x 296 x 410
331 x 396 x558
Electrical
Supply
13amp
13amp
Rating
(kw)
0.3
0.3
Toast Warmer model TW1 Appliance for keeping toasted bread slices warm and crisp.
Ideal for hospitals and health care facilities as part of a Beverage / Hydration trolley
serving toast on the ward. Toast is kept warm between kitchen and bedside, facilitating hot
toast for an entire ward. Thermostat controlled ideally controlled around 40°
Complete with fremovable racks sand hinged perspex door.
Supplied with a 2-meter cable fitted with a 13-amp molded plug for easy installation.
Operation:
• Switch on the unit using the green switch. and adjust to 40
• Allow approximately 20min to warm up.
• Keep door closed for best ecency during service.
• Load the racks with toast.
These units will remain hot for a long period of time after use
4

Before attempting to clean the unit, please ensure that the Unit is isolated from
the electric supply and allowed to cool down, with all food plates and other
Dishes removed from the unit.
Do not use a water jet or pressure spray to clean this appliance.
1. Disconnect trolley from mains and wait until appliance has cooled.
2. Wipe clean using hot, soapy water and soft, non-abrasive cloth. Ensure that the
stainless steel is wiped in straight strokes following the grain of the material.
3. Wipe dry using a clean cloth. Do not use scouring pads or abrasive cleaners of any
type. Shelving and select inner panels can be removed to allow a deeper internal
clean. Ensure all panels and fixings are replaced after cleaning operation.
4. Wipe down doorscreen with a damp, clean cloth.
5. Finish by carefully drying with a soft dry cloth or Kitchen Towels.
4: Cleaning
Do not use scouring pads or abrasive cleaners of any type.
Do not use Solvents, bleach, Caustic Cleaners
or biological powders on any surface.
Special care should be taken around electrical parts,
avoided excessive use of water.
Take special care when cleaning glass use a soft duster & glass cleaner spray.
11: C l e a n i n g
5

E&R Moat Ltd.
Bonnybridge
FK4 2BS
Scotland
Scan the QR code below to visit the
E&R Moat website for further information:
www.ermoat.co.uk
[phone]
sales@ermoat.co.uk
Thank you for choosing E&R Moat!