Monessen Hearth AVFL42RLK User manual

Monessen • AVFL42RLK Front Face Light Kit Instruction Manual • 20305987 Rev. A • 8/17
Front Face Light Kit
Installation Instructions
Model:
AVFL42RLK
for use on AVFL42 Gas Fireplaces
The Front Face Light Kit is designed for use on the AVFL42
model replace and provides indirect lighting framing the
replace ames.
NOTE: The Front Face Light Kit requires installation of
the Face Kit AVFL42WCSS or AVFL42WFBT and is as-
sembled at the same time as the Face Kit.
NOTE: If the Face Kit, AVFL42WCSS or AVFL42WFBT
has already been installed on the replace, it would be
easiest to remove the face, disassemble all parts and fol-
low these instructions.
Read these instructions thoroughly before beginning
installation.
CAUTION: Allow replace to cool completely if it has
been in operation.
Installation Instructions
1. Arrange face parts face down on a non-damaging
surface such as a carpeted oor.
2. Arrange rope light brackets to align with screw holes
in face. NOTE: The angle goes to inside of face kit
frame. Figure 1
3. Screw face parts together with light brackets in place
using 8 (eight) #8 x 3/8” truss-head screws supplied.
Figure 1
4. Install 22 clips in holes in light brackets. NOTE: Clips
go to the outside of the brackets. Figure 2
5. Install the supplied #8 x 3/8” screws into the bracket at
each corner of the face to eliminate gaps that may be
present on the front and sides of the face where parts
meet. Tighten slowly only until gap is eliminated. Do
not over-tighten. The screw which is perpendicular to
the face should always be installed rst. Figure 3
Kit contents:
2, Brackets, Rope Light Top/Bottom
2, Brackets, Rope Light Side
1, Rope Light
22, Clips
12, #8 x 3/8” Truss Head Screws
Tools required: Screwdriver
KT1384
install bracket
Install This Screw First
Install This Screw
Second
KT1384
Figure 3
KT1883
assemble face & Bracket
Figure 1
KT1883
Rope Bracket
Rope
Bracket
Rope Bracket
Rope
Bracket
KT1884
rope light clips
Rope Light Bracket
Clips
KT1884
Figure 2

Monessen • AVFL42RLK Front Face Light Kit Instruction Manual • 20305987 Rev. A • 8/17
6. Insert rope light into clips, starting with nonelectri-
cal end at bottom right corner and working clockwise
around frame. NOTE: The connector end of the rope
light will drape out of frame. Figures 4 & 5
7. Remove screen frame and access panel from re-
place. Remove three (3) screws at top of face, set
aside. Refer to Homeowner’s Manual.
8. Install face by inserting tabs on face into slots on front
of rebox. Secure with four (4) screws (supplied with
face kit) on both bottom tabs and both top tabs.
9. Connect male spade connectors on rope light to fe-
male spade connectors on wire harness marked
“Blower”.
10. Reinstall three (3) screws in slots at top of surround.
11. Reinstall original screen frame and the replacement
access panel.
12. The rope light is controlled using the blower function
on the remote control.
KT1880
KT1880
rope light complete
Rope Light
Clips
Figure 5
KT1881
install rope lightT
Rope Light
Clips
Connector End
Start Here
Figure 4
Monessen, a brand of Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.monessenhearth.com