Monitor Audio Climate Series Service manual

Installation Information

In the box.
NOTE: The following installation steps apply to ALL Climate
products, regardless of orientation.
Bracket
Clamps x 4
(x2 for C60 T2)
Product x 2
(x1 for C60 T2)
Wedge x 2
(x1 for C60 T2)
Bracket x 2
(x1 for C60 T2)
End Cap x 4
(x2 for C60 T2)
Also Included (Located within the packaging):
Wedge Screws x 2 (x4 for C80, x1 for C60 T2). Long screws supplied to be used for widest
part of the wedge. The installer should supply screws for the narrowest part of the wedge
Template x 1
Paint Mask x 2 (x1 for C60 T2)

Bracket fixing options
2
1
2
3
4 4
4
66
4
5
4
4
3
2
1
1. For fixing horizontally into a corner.
Fixings not supplied.
2. For fixing horizontally or vertically
onto a flat wall.
Fixings not supplied.
3. Wall fixing screws for when using
wedge.
Some fixings supplied.
See “Whats in the box”.
4. For securing to an electrical back
box.
Fixings not supplied.
5. Cable through hole.
6. For fixing bracket to wedge.
Fixings not supplied
Use No 6 x 20mm (3/4”) self
tapping screw.
1Choose fixing option
a) Horizontal on flat wall
c) Angled on flat wall (using wedge)
e) In a corner
b) Vertical on flat wall
d) Using electrical junction box

Remove the
magnetic end caps
from product.
Loosely fit the top and bottom bracket clamps
5
6
Drill, fit wall plugs where appropriate and secure bracket
according to your choice of fixing. NOTE: If using the
wedge, fix the bracket to the wedge prior to fixing on the
wall.
4
3Mark required fixing points
87
56
113
65
3
2
1Wall fixing points.
Dimensions in millimetres
Cable through hole. 25mm Diameter max.
Bracket fixing points.
NOTE: Fix bracket to wedge before fitting to wall
template
Climate
1
1
1
33
2
87
56
113
65
3
2
1
Wall fixing points.
Dimensions in millimetres
Cable through hole. 25mm Diameter max.
Bracket fixing points.
NOTE: Fix bracket to wedge before fitting to wall
template
Climate
1
1
1
33
2
Horizontal
Vertical
Using Wedge
NOTE: If Using the wedge,
mark the fixing points using
the template, NOT the
bracket.

Re-fit the magnetic end caps. The end caps might
have to be swapped over, depending on the angle of
the Climate product,
8
Locate the product on the bracket, adjust the direction
accordingly and tighten the clamps.
NOTE: Ensure the pips in the bracket are located correclty on the
product, at both the top and bottom.
NOTE: If re-adjustment of the angle is
required, loosen BOTH of the clamps
and rotate the product, supporting its
weight in the process.
7

Climate Series Specifications:
Specifications Climate 50
Frequency Response 75Hz – 30kHz
Impedance 8 Ohms
Sensitivity (1W @ 1m) 87dB
Power Handling (RMS) 80W
Recommended Amplifier
Requirements (RMS)
10 - 80W
System Configuration 2 way. Rear Firing ABR
Maximum SPL (each) 106.8dBA
Driver Compliment: 1 x 5.5” C-CAM® mid/bass driver.
1 x 1” (25mm) C-CAM® gold dome tweeter.
Overall Dimensions
(H x W x D)
285 x 172.5 x 158.5mm
(11 1/4 x 6 13/16 x 6 1/4”)
Total Depth inc Bracket (exc Wedge) 210mm (8 1/4”)
Total Pivot Angle 87.5 Degrees (from central position)
Wedge Angle 15 Degrees
Environmental Protection Rating IP56
Weight kg (lb) 3.66 (8.05)
Specifications Climate 60 T2
Frequency Response 63Hz – 30kHz
Impedance 2 x 8 Ohms
Sensitivity (1W @ 1m) 88dB
Power Handling (RMS) 2 x 50W
Recommended Amplifier
Requirements (RMS)
15 - 100W
System Configuration 2 way. Rear Firing ABR
Maximum SPL (each) 106.8dBA
Driver Compliment: 1 x 6.5” C-CAM® mid/bass driver
with dual voice coil.
2 x 1” (25mm) C-CAM® gold dome tweeter.
Overall Dimensions
(H x W x D)
325 x 185 x 178.5mm
(12 13/16 x 7 5/16 x 7”)
Total Depth inc Bracket (exc Wedge) 235mm (9 1/4”)
Total Pivot Angle 87.5 Degrees (from central position)
Wedge Angle 15 Degrees
Environmental Protection Rating IP56
Weight kg (lb) 5.02 (11.04)
Specifications Climate 60
Frequency Response 63Hz – 30kHz
Impedance 8 Ohms
Sensitivity (1W @ 1m) 88dB
Power Handling (RMS) 100W
Recommended Amplifier
Requirements (RMS)
15 - 100W
System Configuration 2 way. Rear Firing ABR
Maximum SPL (each) 108.8dBA
Driver Compliment: 1 x 6.5” C-CAM® mid/bass driver.
1 x 1” (25mm) C-CAM® gold dome tweeter.
Overall Dimensions
(H x W x D)
325 x 185 x 178.5mm
(12 13/16 x 7 5/16 x 7”)
Total Depth inc Bracket (exc Wedge) 235mm (9 1/4”)
Total Pivot Angle 87.5 Degrees (from central position)
Wedge Angle 15 Degrees
Environmental Protection Rating IP56
Weight kg (lb) 4.62 (10.16)
Specifications Climate 80
Frequency Response 50Hz – 30kHz
Impedance 8 Ohms
Sensitivity (1W @ 1m) 89.5dB
Power Handling (RMS) 120W
Recommended Amplifier
Requirements (RMS)
20 - 120W
System Configuration 2 way. Rear Firing ABR
Maximum SPL (each) 111.1dBA
Driver Compliment: 1 x 8” C-CAM® mid/bass driver.
1 x 1” (25mm) C-CAM® gold dome tweeter.
Overall Dimensions
(H x W x D)
405 x 230 x 221mm
(15 15/16 x 9 1/16 x 11 11/16”)
Total Depth inc Bracket (exc Wedge) 272.5mm (10 3/4”)
Total Pivot Angle 87.5 Degrees (from central position)
Wedge Angle 15 Degrees
Environmental Protection Rating IP56
Weight kg (lb) 6.53 (14.37)

Monitor Audio Ltd
24 Brook Road, Rayleigh
Essex, SS6 7XJ
England
Tel: + 44 (0)1268 740580
Fax: + 44 (0)1268 740589
Email: [email protected]
monitoraudio.co.uk
Designed in the United Kingdom
Version 1.