Monte Carlo Fan Company MCM360 User manual

Customer Service
800-969-3347
Customer Service Center
7400 Linder Ave.
Skokie, IL 60077
www.montecarlofans.com
MCM360 BLANKING PLATE
READ AND SAVE THESE INSTRUCTIONS
Warning: Make sure main power is turned off before handling Parts
replacement.
Installation work and electrical wiring must be done by qualified person(s). If you
are unfamiliar with methods of installing or electrical wiring, secure the service of a
qualified electrician.
All electrical connections must be in accordance with local codes, ordinances, and
national electrical codes.
Review the installation instructions supplied with your fan. Make sure that your fan
has been installed and wired properly.
Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver,
Pliers, Safety Glasses, Stepladder and Wire Strippers

2
© 2015 Monte Carlo Fan Company 06/05/2015
ON
OFF
ON
OFF
Before you begin handling light kit
replacement, Switch power off at Service
panel and lock service disconnecting
means to prevent power from being
switched on accidentally. When the
service disconnecting means cannot be
locked, securely fasten a warning device,
such as a tag, to the service panel.
Remove glass from light pan by turning
counterclockwise.
Remove LED light fixture by uninstalling
the 3 set screws and turning
counterclockwise.
Disconnect the plug from fan and plug
from LED light fixture.
Warning: Make sure main power is
turned off before handling light kit
replacement.
Attach blanking plate onto light pan by
locating dimples in light pan with grooves
in blanking plate and twist clockwise until
tight.
LED light fixture
Light pan
Glass
Blanking plate
1 2 3
4 5

Jun.2015