
EN - 11
F
AB
C
C
D
E
G
I
J
K
Installation in a wall unit
After making the electrical connections,
insert the oven into the cabinet by pushing
it forward. Open the oven door and insert
2 screws in the holes located on the oven
frame. While the product frame touches the
wooden surface of the cabinet, tighten the
screws.
2.3 Electrical Connection and Safety
WARNING: The electrical connection
of this appliance should be carried out
by an authorised service person or
qualified electrician, according to the
instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST
BE EARTHED.
•Before connecting the appliance to the
power supply, the voltage rating of the
appliance (stamped on the appliance
identification plate) must be checked for
correspondence to the available mains
supply voltage, and the mains electric
wiring should be capable of handling the
appliance’s power rating (also indicated
on the identification plate).
•Do not use adaptors, multiple sockets
and/or extension leads.
•The supply cord should be kept away
from hot parts of the appliance and
must not be bent or compressed.
Otherwise the cord may be damaged,
causing a short circuit.
•
•During installation, please ensure that
isolated cables are used. An incorrect
connection could damage your
appliance. If the mains cable is
damaged and needs to be replaced
this should be done by a qualified
personnel.
•If the appliance is not connected to
the mains with a plug, a multi-pole
isolator switch (with at least 3 mm
contact spacing) must be used in
order to meet the safety regulations.
•The appliance is designed for a power
supply of 220-240V ~ and 380-415V
3N~. If your supply is different,
contact the authorised service person
or a qualified electrician.
•The power cable (H05VV-F) must be
long enough to be connected to the
appliance, even if the appliance
stands on the front of its cabinet.
•Ensure all connections are
adequately tightened.
•Fix the supply cable in the cable
clamp and then close the cover.
•The terminal box connection is placed
on the terminal box.
Brown Yellow+Green
Blue
It is important to make sure
that the appliance can be isolated if
required without having to touch or
remove the appliance.