MORryde TV1-022H User manual

MORryde International ▪ 1966 Sterling Avenue ▪ PO Box 579 ▪ Elkhart ▪ IN 46516
Customer Service: 574-293-1581 ▪ www.morryde.com
Hardware for mounting television:Refer to your television’s owners manual or select the appropriate bolt from the hardware provided.
M4x12mm Bolt (4)
M4 Lock Washer (6)
M4x30mm Bolt (4)
M5x12mm Bolt (4)
M5 Lock Washer (6)
M5x30mm Bolt (4)
M4 M5
Hardware for securing bracket: Select the appropriate length based on the thickness of your mounting surface.
< best for wood applications >
#10 Flat Washer (4)

STEP 2 Secure mount to reinforced
ceiling or mounting surface:
Pre-drill holes using a 1/8” drill bit.
Use lag bolts or appropriate hardware
for the sturcture to secure the mount
to the reinforced mounting surface.
STEP 3 Secure the television or monitor to the mount:
Line up the hole pattern on your television with the
matching hole pattern on the mounting plate. Using the
appropriate mounting hardware and washers, secure
the television to the mounting plate.
CAUTION: Using a screw
or bolt length that is too
long for your application
may result in puncturing
exterior structure.
Optional Washer (4)Lock Washer (4)Bolt (4)
CAUTION: Structure must be reinforced
- the size and weight of your television plus the
weight of the mount must be properly supported.
MORryde is responsible for the design and
manufacturing of our parts; we are not responsible
for the structure it is mounted to or the construction
method used to reinforce the mounting surface.
Loosen knobs on side
to tilt and then tighten
in place for desired
viewing angle.
Loosen knob in back to
swivel and then tighten
in place for desired
viewing angle.
NOTE: This step may require two people. MORryde is not
responsible for property damage and/or personal injury.
STEP 1 Assemble mount:
a)To add base extension, use hammer to tap spring pin
in place. b) Slide VESA adapter plate to desired height
and secure with nut and bolt.
a) b)