STEP 1 Secure the wall bracket to mounting surface:
Pre-drill holes using a 1/8” drill bit for use with 1/4” lag bolts. Use lag bolts or self drilling
screws (depending on your mounting surface) with 1/4” washers to secure base of
bracket to the mounting surface.
CAUTION:
Using a screw or bolt length that
is too long for your application may result in
puncturing exterior structure.
CAUTION:
This step may require two people to lift the television onto the bracket and
secure. MOR/ryde is not responsible for property damage and/or personal injury.
STEP 3 Secure the television to mounting plate: Line up the hole pattern on your
television with the matching hole pattern on the universal mounting plate as close to the
center as possible. Using the appropriate mounting hardware, washers, and optional
spacers, secure the television to the mounting plate.
STEP 2 Wiring:
Connect green switch wire to red motor wire. Connect yellow switch wire to black motor
wire. Connect RED switch 12 volt (+) to 12 volt constant power. Connect Black switch
Ground (-) to ground.
BLACK MOTOR WIRE
TO YELLOW SWITCH WIRE
RED MOTOR WIRE
TO GREEN SWITCH WIRE
