motif CAD0001 User manual

Before using, please read the user manual
carefully and follow the instructions to
operate properly.

Thank you for purchasing the Clean-Z CPAP Sanitizer,
which is used to sanitize germs and bacteria by
producing O3. You can use it to sanitize your CPAP
mask and tubing. The entire sanitization requires no
water or other chemical cleaning.
Warning:
*Keep this product out of the reach of children.
*Do not disassemble or attempt to repair this
product, as it may cause damage to the device.
*Do not get the device wet and avoid all liquids when
using it.
*Do not use in combustive air environments, near
gas vapors or other flammables, etc.
*Use the original power adapter and USB cable.

1）Start-Up Stage: When the Clean-Z is powered on
there is a one minute preparation period with a
single beep. You will see a slow flashing red LED
light with no ozone produced.
2）Cleaning Stage: After the start-up stage, the
Clean-Z will start to produce ozone and work
continuously for 30 minutes. The red LED light will
cycle from LED to .
3）Fresh Air Stage: The Clean-Z will stop producing
ozone with a green LED light cycling from LED to
. The fan will run for five minutes to flush the
residual ozone.
4）Cleaning Complete: The Clean-Z will stop
working automatically with three green LED lights
on and three beeps.

To clean the CPAP mask and tubing:
Put the mask and tubing into the sanitizing bag and
connect the Clean-Z by the ozone port. Power the
Clean-Z on to start the sanitization process.
Filter Cartridge: This filter converts ozone back into
regular air. Replace the filter once every six months.
Warning: After the sanitization process, wait at least
an hour before using the CPAP equipment to ensure
no ozone resides.

1. When not in use, please store your Clean-Z.
2. Do not place the Clean-Z in a damp area or in
direct sunlight for a prolonged period.
3. When using the Clean-Z to sanitize, please put
it in a dry, clean and ventilated environment.
4. Keep the Clean-Z and the sanitizing bag dust-free
by periodically wiping it down with a damp cloth.
If the bag gets dirty, you may hand wash it and
allow it to air dry. Do not machine wash or
machine dry the bag.
Size
Weight
Air flow
Powerconsumption
Power suplpy
Store temperature
Operation temperature
4.1x2.4x1.6 in
4.4 ounces
3.5 CFM
10W
DC 4.5V~6.5V
-4 to 131
23 to 113

The Clean-Z does
not work after
turning on.
No flashing light
or beeping sound
The Clean-Z
doesn’t stop
automatically. .
No 03 generation
in one minute after
it is powered on.
Connect the Clean-Z to the
adapter. Plug the adapter
into the power source. Turn
on the Clean-Z.
Make sure the power con-
nection is correct. If the pr-
oblem is still not resolved,
please send it in for repairs.
Turn the device off and then
on. If the problem persists,
contact us at [phone].
Power the Clean-Z on again.
If the problem persists,
contact us at [phone].
This marking indicates that this product should not
be disposed of with other household wastes. To
prevent possible harm to the environment or
human health from uncontrolled waste disposal,
recycle this product responsibly to promote the
sustainable reuse of material resources.
To return your used device, please use the return and collection
system or contact the retailer where the product was purchased.
They can safely recycle this product.

Manufactured for:
Motif Medical, LLC
Dover, DE 19901
www.motifclean-z.com
[phone]