motif CLEAN-Z User manual

Clean PAP Mask and Tubing
Insert Filter into Bag and connect mask to tubing, and place into
bag. Close bag around tubing using velcro. Attach Clean-Z to end
of tubing. Connector adapter might be needed based on your
PAP equipment.
Clean CPAP Device and Tubing
Connect Clean-Z to CPAP tubing, and then the tubing to the
PAP Device. Connector adapter might be needed based on your
PAP equipment.
Start Cleaning Process
Connect power supply to Clean-Z, and plug into electrical outlet.
Press Power button and Clean-Z will start and automatically run
through a complete cleaning cycle.
Insert
Filter
Mask
Inside
Power
Button
Clean-Z Quick Guide | Assemble Unit
1

Stages
Prep Stage: Device will beep and display a slow flashing Red light.
Cleaning Stage: Sequenced Red light indicates ozone is being
produced sanitizing your device.
Fresh Air Stage: Device will now purge ozone from
PAP and show a sequence of Green lights.
Complete: Sanitization is complete, and device will
beep and then show three solid Green lights.
Indications of Use
Clean-Z is designed to sanitize an individual’s Positive Airway
Pressure (PAP) equipment and mask. Individuals who use a PAP
machine for Obstructive Sleep Apnea (OSA) can use Clean-Z to
sanitize all PAP equipment on a daily basis, or when the user
wants the added benefit of thorough sanitization.
See Manual for full list of Warnings
Warning: Use only in well ventilated room. Allow device to complete all cycles.
Warning: Keep away from all water sources. Keep away from flame or fire.
Warning: Keep away from children, this is not a toy.
Warning: Do not dissemble or dismantle the Clean-Z device.
Warning: Do not run Clean-Z for more than two consecutive cycles.
Warning: Do not use Clean-Z while your PAP machine is in use. Clean-Z is not
a PAP Machine.
!
Clean-Z Quick Guide | Use Unit
2
Manufactured for:
Motif Medical LLC
Dover, DE 19901
For More Information Visit
www.motifclean-z.com