motif Clean-Z CPAP Ozone Sanitizer User manual

Insert the filter into the bag and connect the mask to the tubing.
Place the mask into the bag. Close the bag around the tubing
using the velcro. Attach the Clean-Z to the end of the tubing.
The connector adapter might be needed based on your PAP
equipment.
Connect the power supply to the Clean-Z and plug into an
electrical outlet. Press the power button. The Clean-Z will start
and automatically run through a complete cleaning cycle.
Clean-Z Quick Guide | Assemble Unit
Clean PAP Mask and Tubing
Start Cleaning Process

The Clean-Z is designed to sanitize an individual’s Positive Airway
Pressure (PAP) mask. Individuals who use a PAP machine for
Obstructive Sleep Apnea (OSA) can use the Clean-Z to sanitize
on a daily basis or when the user wants the added benefit of
thorough sanitization.
Clean-Z Quick Guide | Use Unit
Prep Stage: The device will beep and display a slow flashing
red light.
Cleaning Stage: The sequenced red light indicates ozone is
being produced, sanitizing your device.
Fresh Air Stage: The device will now purge ozone from the PAP
and show a sequence of green lights.
Complete: The sanitization is now complete. The device will
beep and then show three solid green lights.
Prep Stage:
Cleaning Stage:
Fresh Air Stage:
Complete:
See manual for a full list of warnings
Warning: Only use in a well-ventilated room. Allow the device to complete
all cycles.
Warning: Keep away from all water sources. Keep away from flame or fire.
Warning: Keep away from children.
Warning: Do not disassemble or dismantle the Clean-Z device.
Warning: Do not run the Clean-Z for more than two consecutive cycles.
Warning: Do not use the Clean-Z while your PAP machine is in use. The
Clean-Z is not a PAP machine.
For more information visit:
www.motifclean-z.com
Manufactured for:
Motif Medical LLC
Dover, DE 19901
Stages
Indications of Use