Motorola MOTO BUDS 270 ANC User manual

MOTO BUDS 270 ANC
BLUETOOTH TRUE WIRELESS EARBUDS
For: MOTO BUDS 270 ANC
User Guide

Safety instructions
DANGER
To avoid hearing damage, limit the time you use earbuds at
high volume and set the volume to a safe level. The louder the
volume, the shorter the safe listening time is.
WARNING
This true wireless earbuds are compliant with all relevant standards regarding
electromagnetic fields and is, when handled as described in the User Guide,
safe to use. Therefore, always read the instructions in this User Guide carefully
before using the device.
• Listen at reasonable volumes for reasonable periods of time.
• Be careful not to adjust the volume continuously upwards as your hearing
adapts.
• Do not turn up the volume so high that you can't hear what is around you.
• You should use caution or temporarily discontinue use in potentially
hazardous situations.
• Excessive sound pressure from earbuds can cause hearing loss.
• Using earbuds with both ears covered while driving is not recommended
and may be illegal in some areas while driving.
• For your safety, avoid distractions from music or phone calls while in trac
or other potentially dangerous environments.
CAUTION
• Do not expose earbuds to excessive heat.
• Do not drop your earbuds.
• Earbuds shall not be exposed to dripping, splashing water.
• Do not allow your earbuds to be submerged in water.
• Do not use any cleaning agents containing, alcohol, ammonia, benzene, or
abrasives.
• If cleaning is required use a soft cloth, if necessary dampened with a
minimum amount of water or diluted with a minimum amount of water or
diluted mild soap, to clean the earbuds.
• The integrated battery shall not be exposed to excessive heat such as
sunshine, fire or the like.

• Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding
environment can result in an explosion or the leakage of ammable liquid or
gas.
• A battery subjected to extremely low air pressure that may result in an
explosion or the leakage of ammable liquid or gas.
• Replacement of a battery with an incorrect type that can defeat a
safeguard (for example, in the case of some lithium battery types).
Operating temperature and humidity
• Store in a place where temperature is between -20°C (-4°F) to 50°C
(122°F) (up to 90% relative humidity with no condensation).
• Operate in a place where temperature is between 0°C (32°F) to 45°C
(113°F) (up to 90% relative humidity with no condensation).
• Battery life may be shorter in high or low temperature conditions.

Welcome...
to your new Motorola 270 ANC Bluetooth true wireless earbuds!
• Wireless charging case.
• Up to 18 hours total playtime with the charging case
• Touch control for auto on/o and music play/pause.
• Dual connection from each bud to your mobile handset for improved
quality and better listening experience.
• Water resistant buds (IPX5).
• Built-in mic for handsfree voice calls
• Smart voice assistant (Siri®and Google AssistantTM) .
• Bluetooth 5.2
Need help?
If you have any problems setting up or using your MOTO BUDS 270 ANC,
please visit us at motorolasound.com/support
Alternatively, you may find the answer in the ‘Help’ section at the back of
this guide.

This User Guide provides you with all the information
you need to get the most from your Bluetooth true
wireless earbuds.
Before you make call or listen to music you will
need to set up your Bluetooth true wireless earbuds.
Follow the simple instructions in ‘Getting started’, on
the next few pages.
Got everything?
• Bluetooth true wireless earbuds (with M size earcaps)
• Charging case
• USB-C charging cable
• Extra 2 pairs (S and L sizes) of replaceable earcaps
• Quick start guide

6
1. Getting started ................................................................... 7
2. Getting to know your true wireless earbuds...........9
3. Using the true wireless earbuds ................................ 10
3.1 Select the earcaps .......................................................................................... 10
3.2 Wear the earbuds ........................................................................................... 10
3.3 Reconnect the earbuds to your Bluetooth device............................. 10
3.4 Operation .............................................................................................................11
3.4.1 Turn on/o...........................................................................................11
3.4.2 Call control ..........................................................................................11
3.4.3 Music ......................................................................................................11
3.4.4 Activate voice assistant..................................................................11
3.4.5 Noise cancellation and ambient sound ....................................11
3.4.6 Restore factory settings................................................................12
3.5 LED status indicators ........................................................................... 12
4. Help........................................................................................13
5. Technical Specifications................................................ 14
6. General information.........................................................15

7
1. Getting started
Location
Important
The earbuds are resistant to dripping and splashing water, but the charging
case is not waterproof. Make sure you wipe o any moisture on the earbuds
thoroughly before putting them into the charging case.
Range of earbuds and the Bluetooth device
Make sure the earbuds and Bluetooth device are placed within range of each
other.
Charging the battery
Important
Warning! Use only the approved rechargeable Lithium-ion battery supplied
with your MOTO BUDS 270 ANC.
Charging case
Connect one side of the supplied USB-C charging cable to the Type-C
charging port, and the other side to the USB AC adaptor.
Fig. 2a
The LED indicators on the charging case flash then stay on when charging is
complete. They show the current battery level. For the first time use, charge
the battery for at least 5 hours continuously. After the first time charge, it takes
approximately 2 hours for a normal charge.
Battery performance
In ideal conditions, a fully charged battery should give up to 6.0 hours usage
time or up to 50 hours standby time.
The charge capacity of the rechargeable battery will reduce with time as it
wears out, giving the earbuds less usage / standby time.
Getting started

8
Battery low warning
If you hear 'LOW BATTERY' every 3 minutes, recharge the battery.
Earbuds
Put the earbuds into the charging case. Charging starts automatically. The red
LEDs on both earbuds turn on until charging is complete.
Connecting your earbuds
Pair your earbuds with the Bluetooth device for the first time
1. Open the charging case top lid to turn earbuds on.
• You will hear 'POWER ON'. The LEDs on both earbuds will flash blue for
a second and you will hear 'LEFT CHANNEL', 'RIGHT CHANNEL'.
• Then the LED indicator flashes every 5 seconds on the left earbud and
red and blue alternately on the right earbud. Earbuds enter pairing
mode. You will hear 'PAIRING'.
2. Make sure the Bluetooth function of you device is activated. Earbuds will
do pairing automatically.
3. Select MOTO BUDS 270 ANC from the Bluetooth menu of your device. You
will hear 'HELLO MOTO, CONNECTED' when pairing is successful. The blue
LED on both earbuds will flash slowly.
Note
Make sure your device is compatible with Bluetooth and earbuds.
Your MOTO BUDS 270 ANC are now ready for use.
Fig. 2b
MOTO BUDS 270 ANC
Fig. 3b
Fig. 3a
Getting started

9
2. Getting to know your true wireless earbuds
Overview
1 Microphones
2 Multi-function button (MFB)
3 LED indicators
4 Replaceable earcaps (size M)
5 Charging case
6 USB Type-C charging socket
7 Earbud charging contacts
8 Battery level indicators
2
1
3
4
Fig. 1a
6
5
Fig. 1b
8
7
Fig. 1c
Getting started

10
3. Using the true wireless earbuds
3.1 Select the earcaps
1. Select from 3 dierent size of replaceable earcaps which fit your ears the
best. The earbuds come with size M attached as default.
2. Fit the earcaps into the earbuds.
3.2 Wear the earbuds
Insert the earbuds into ears and rotate to fit comfortably.
3.3 Reconnect the earbuds to your Bluetooth device
1. Turn on your Bluetooth device with the Bluetooth feature activated.
2. Open the charging case top lid to turn on your earbuds.
• The earbuds will auto reconnect to the last connected Bluetooth device.
Note
If the earbuds cannot find and connect to any Bluetooth device with 5 minutes,
they will switch o automatically.
Fig. 4a
Fig. 4b
Fig. 4c
Using the true wireless earbuds