Motorola PTP 600 Series User manual

PTP 600 Series
User Guide
MOTOROLA POINT-TO-POINT WIRELESS SOLUTIONS

1
MOTOROLA, Inc.
Point-to-Point Wireless Bridges – PTP 600 Series
Software Release PTP 600-04-01
System User Manual
April 02nd, 2007
Ref: PHN-0896-01.04
Copyright Information
This document is the confidential property of Motorola, Inc. and without its prior written consent may
not be copied or released to third parties.
MOTOROLA, the stylized M Logo and all other trademarks indicated as such herein are trademarks
of Motorola, Inc. ® Reg. U.S. Pat & Tm. Office. PTP 600 is a trademark of Motorola, Inc. All other
product or service names are the property of their respective owners.
© 2007 Motorola, Inc. All rights reserved.
http://www.motorola.com
Compliance
General
Changes or modifications not expressly approved by Motorola could void the user’s authority to
operate the system.
NOTE: This system has achieved Type Approval in various countries around the world. This means
that the system has been tested against various local technical regulations and found to comply. The
frequency band in which the system operates is ‘unlicensed’ and the system can be used provided it
does not cause interference. Further, it is not guaranteed protection against interference from other
products and installations.

2
The system has basically been shown to comply with the limits for emitted spurious radiation for a
Class B digital device1, pursuant to Part 15 of the FCC Rules in the USA as well as comparable
regulations in other countries. These limits have been designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the Outdoor Unit (ODU).
•Increase the separation between the equipment and ODU.
•Connect the equipment into a power outlet on a circuit different from that to which the
receiver is connected.
Consult your installer or supplier for help.
Deployment and Operation
The Radio Regulations of various countries’ limits constrain the operation of radio products generally.
In particular the local regulator may limit the amount of conducted or radiated transmitter power and
may require registration of the radio link.
The power transmitted by the PTP 600 Series Bridge is controlled by the use of Region-specific
License Keys.
The following examples show how the regulatory limits apply in some specific countries at the current
time. Operators should note that regulations are subject to change.
Contact your supplier/installer to ensure that your product is set for the correct License Key for your
Country/Region and to ensure that you have fulfilled all the local regulatory requirements, especially if
you are intending to use a link with external antennas. Footnotes to the table below indicate countries
where registration of the link is currently mandatory.
1Class B Digital Device, A digital device that is marketed for use in a residential environment notwithstanding use in
commercial, business and industrial environments.

3
Regulations applicable to 5.4GHz PTP 600 Series Bridge variant
Examples of Regulatory Limits at 5.4GHz
Power/Radiated Power/Region Setting
Non-FCC and Non-ETSI2Equipment can be operated in any mode, best
results will be obtained using Region 8 settings
(Region 7 if DFS is required)
FCC Under FCC Regulations, operation of this product is
only allowed with a License Key for Region 12
(30dBm EIRP with Radar Detection)
Canada
Under IC Regulations, operation of this product is
only allowed with a License Key for Region 13
(30dBm EIRP with Radar Detection and barring of
the band 5600-5650MHz)
ETSI Under ETSI Regulations, operation of this product i
only allowed with a License Key for Region 12
(30dBm EIRP with Radar Detection)
s
General Notice Applicable to Europe
This equipment complies with the essential requirements for the EU
R&E Directive 1999/5/EC.
And
2Note: In regions other than EU/USA, specific local regulations may apply. It is the responsibility of the installer/user to check
that the equipment as deployed meets local regulatory requirements.

4
Regulations applicable to 5.8GHz PTP 600 Series Bridge variant
Examples of Regulatory Limits
Power/Radiated Power/Region Setting
USA/ Canada/ Taiwan/ Brazil Equipment can be operated in any mode, best
results will be obtained using Region 1 settings
UK3Under UK Regulations, operation of this product is
allowed with a License Key for Region 4 (2W EIRP
with Radar Detection)
Eire4Under Eire Regulations, operation of this product is
only allowed with a License Key for Region 6 (2W
EIRP)
Norway
Norwegian rules allow a 200W EIRP but also
require Radar Detection (DFS) and barring of part
of the band. The license key for Region 7 is
required, although Region 4 could also be used fo
r
lower power requirements.
Australia
A
ustralian laws prohibit use/operation of this
product except where it is used with a License Key
for Region 3 (4W EIRP)
Singapore Under Singapore Regulations, operation of this
product is only allowed with a License Key fo
r
Region 5 (100mW EIRP)
Hong Kong Under Hong Kong Regulations, operation of this
product is only allowed with a License Key fo
r
Region 3 (4W EIRP)
Korea
Under Korean Regulations, operation of this product
is only allowed with a License Key for Region 11
(100mW TX Power, Band restricted to 5725 to
5825MHz)
3UK Registration of Links – OfCom
The application form may be found at
http://www.ofcom.org.uk/radiocomms/
4Eire Registration of Links – Commission for Communication Regulation (ComReg)
The application form may be found at
http://www.comreg.ie/5_8GHzRegPart1.asp?S=4&NavID=198&M

5
General Notice Applicable to Europe
This equipment complies with the essential requirements for the EU
R&E Directive 1999/5/EC.
The use of 5.8GHz for Point to Point radio links is not harmonized
across the EU and currently the product may only be deployed in
the UK and Eire (IRL); Norway will be available for deployment from
December 2005.
However, the regulatory situation in Europe is changing and the
radio spectrum may become available in other countries in the nea
r
future. Please contact Motorola for the latest situation.
!GB
IRL
0889
Disclaimer
The parameters quoted in this document must be specifically confirmed in writing
before they become applicable to any particular order or contract. The company
reserves the right to make alterations or amendments to the detail specification at its
discretion. The publication of information in this document does not imply freedom
from patent or other rights of Motorola, Inc. or others.

6
1About This User Guide.......................................................................................................18
1.1 Interpreting Typeface and Other Conventions......................................................................18
1.2 Getting Additional Help .........................................................................................................20
1.3 Sending Feedback ................................................................................................................20
2Avoiding Hazards................................................................................................................21
2.1 Preventing Overexposure to RF Energy...............................................................................21
2.1.1 Calculations for Separation Distances and Power Compliance Margins..............................21
2.1.1.1 Calculated Distances and Power Compliance Margins........................................................22
3Getting Started ....................................................................................................................23
3.1 For Your Safety.....................................................................................................................23
3.2 Welcome ...............................................................................................................................24
3.2.1 About This Guide...................................................................................................................24
3.2.2 Who Should Use This Guide.................................................................................................24
3.2.3 Contact Information...............................................................................................................25
3.2.4 Repair and Service................................................................................................................25
3.3 Product Description...............................................................................................................26
3.3.1 The Outdoor Unit (ODU).......................................................................................................28
3.3.2 PIDU Plus – PTP 600 Series Bridge.....................................................................................29
3.3.3 Redundancy and Alternate Powering Configurations...........................................................31
3.3.3.1 External DC Supply Only ......................................................................................................31
3.3.3.2 External DC Supply and AC Supply......................................................................................32
3.3.3.3 External DC Supply and Redundant AC Supply...................................................................32
3.3.4 Remote LEDs and Recovery Switch.....................................................................................33
3.3.5 Cables and connectors .........................................................................................................33
3.3.6 Surge Arrestor.......................................................................................................................34
3.3.7 Mounting Brackets.................................................................................................................34
3.3.8 Configuration and Management............................................................................................35
3.4 Warranty................................................................................................................................35
4Product Architecture ..........................................................................................................36
5General Considerations .....................................................................................................38
5.1 Spectrum Planning................................................................................................................38
5.2 Region Codes........................................................................................................................39
5.3 Operational Restrictions........................................................................................................40
5.3.1 Radar Avoidance...................................................................................................................40
5.3.2 RTTT Avoidance and Other Channel Use Restrictions........................................................41

7
5.4 5.4GHz Specific Frequency Planning Considerations..........................................................42
5.4.1 Raster Considerations...........................................................................................................43
5.4.2 Transmit Power Reduction at the Band Edges.....................................................................43
5.4.3 5.8GHz Specific Frequency Planning Considerations..........................................................43
5.4.4 Raster Considerations...........................................................................................................44
5.4.5 Transmit Power Reduction at the Band Edges.....................................................................44
5.5 Distance ................................................................................................................................44
5.6 Networking Information .........................................................................................................45
5.7 Lightning Protection...............................................................................................................45
5.8 Electrical Requirements ........................................................................................................45
6Site Planning........................................................................................................................46
6.1 Site Selection Criteria............................................................................................................46
6.1.1 ODU Site Selection ...............................................................................................................46
6.1.2 PTP 600 Series Bridge PIDU Plus Site Selection.................................................................46
6.1.3 Path Loss Considerations.....................................................................................................47
6.1.4 Aggregate Ethernet throughput rate v maximum link loss....................................................48
7Installation ...........................................................................................................................50
7.1 Preparation............................................................................................................................50
7.2 Installation Procedure ...........................................................................................................50
7.3 Tools Required......................................................................................................................50
7.4 Installation Support................................................................................................................51
7.5 Legal Disclaimer....................................................................................................................51
7.6 Mounting the ODUs...............................................................................................................51
7.7 Connecting Up.......................................................................................................................53
7.7.1 Preparing The PIDU Plus To ODU Cable.............................................................................53
7.7.2 Making the Connections at the ODU.....................................................................................55
7.7.3 Making the PTP 600 Series Bridge PIDU Plus Connection At The ODU.............................56
7.7.4 Routing the Cable..................................................................................................................57
7.7.5 Fitting A Surge Arrestor.........................................................................................................57
7.7.6 Grounding the Installation.....................................................................................................58
7.7.7 Making the ODU Connection at the PTP 600 Series Bridge PIDU Plus...............................58
7.7.8 Making the Network Connection at The PIDU Plus – PTP 600 Series Bridge .....................59
7.7.9 Mounting the PTP 600 Series Bridge PIDU Plus..................................................................60
7.7.10 Powering Up..........................................................................................................................62
7.7.11 Aligning the PTP 600 Series Bridge ODUs...........................................................................63
8Web Page Reference...........................................................................................................65

8
8.1 Home Page – PTP 600 Series Bridge...................................................................................67
8.1.1 Home Page Alarm Display....................................................................................................68
8.2 Systems Status Page............................................................................................................71
8.3 System Administration Pages...............................................................................................76
8.3.1 System Configuration............................................................................................................77
8.3.1.1 General Configuration Page..................................................................................................78
8.3.1.2 LAN Configuration Page .......................................................................................................80
8.3.1.3 LAN Configuration Page – Use VLAN For Management Interfaces.....................................83
8.3.1.4 LAN Configuration Page – Manual Ethernet Configuration ..................................................85
8.3.1.5 Save and Restore Configuration File....................................................................................86
8.3.1.6 Telecoms Configuration Page...............................................................................................91
8.3.2 Statistics Page.......................................................................................................................93
8.3.3 Detailed Counters Page........................................................................................................96
8.3.4 Install Pages..........................................................................................................................98
8.3.4.1 Manually Configuring The Wireless Units...........................................................................100
8.3.4.2 Internet Protocol Configuration ...........................................................................................101
8.3.4.3 Telecoms Interface..............................................................................................................103
8.3.4.4 Wireless Configuration........................................................................................................104
8.3.4.5 Disarm.................................................................................................................................110
8.3.5 Graphical Install...................................................................................................................112
8.3.6 Software Upgrade ...............................................................................................................113
8.3.7 Spectrum Management.......................................................................................................116
8.3.7.1 Wireless Channels ..............................................................................................................117
8.3.7.2 Spectrum Management Measurements..............................................................................117
8.3.7.3 Measurement Analysis........................................................................................................117
8.3.7.4 The Spectrum Management Master / Slave Relationship...................................................118
8.3.7.5 Spectrum Management Configuration ................................................................................121
8.3.7.6 Barring Channels.................................................................................................................122
8.3.7.7 Local and Peer Channel Spectrum Graphics......................................................................122
8.3.7.8 Active Channel History........................................................................................................124
8.3.7.9 Viewing Historic Spectrum Management Metrics ...............................................................125
8.3.8 Spectrum Management (Fixed Frequency and WIMAX)....................................................126
8.3.9 Spectrum Management Control - With Operational Restrictions........................................128
8.3.10 Remote Management Page................................................................................................131
8.3.10.1 SNMP (Simple Network Management Protocol).................................................................132
8.3.10.2 Supported Management Information Bases (MIBS)...........................................................132