
toll free: 1-877-706-4480
international/local: 713-706-4480
fax: 713-706-4161
www.MS3C.co
3. Operator(s) will maintain guide angle.
4. TOP operator will apply pressure slightly down while SUPPORT operator (when available) applies pressure
slightly up. This will keep tracks engaged with stairs
5. Operator(s) will push “UP” button on control panel and guide chair up one stair at a time.
6. Spotter (if applicable) will be positioned below SUPPORT operator (when available).
7. Once at top of stairs, TOP operator will back up far enough to
safely tilt chair into its full upright position making sure front
wheels are securely placed on ground.
8. SUPPORT operator (when available) retracts telescoping control
handles back to locked closed position.
9. TOP operator will then disengage track by pushing red release bar
located on back of chair and pushing it upward and inward.
Disengaging track will engage rear wheels.
10. Make sure track is in closed locked position by pulling on it in and
out. If track does not move, track is locked.
11. To roll chair, TOP operator will engage push handles and direct
chair as necessary.
To Fold Chair:
1. Turn off battery, by turning key to off position.
2. Remove and set aside removable backrest.
3. Place chair backwards onto its track.
4. Grab backrest with one hand and pull red folding bar
located under chair with or hand.
5. Guide chair into its folded position.
6. Use seatbelt to secure chair into its folded position by
placing seat belt around outside of chair and locking it. Pull
seatbelt tight to secure chair into its locked position.
7. When not in use, battery should be charged.
To Charge Battery:
1. When chair is not in use, make sure to charge battery.
2. To charge battery, unscrew the retainer ring on the power supply cable plugged into battery. Remove the plug
from battery.
3. Insert power plug from supplied external power converter into battery.
4. Plug power converter into a standard wall socket.
5. Before use, check power charge on battery.
6. To use chair, unplug external power converter from wall socket.
7. Remove external power plug from the battery.
8. Insert chair’s power plug into battery and tighten retaining ring.
9. Push On Power Button on Control Panel to operate chair.