MSA altair 5 Technical manual

0121 Rev. 0 1-800-MSA-2222 / www.MSAnet.com 10117074
Please review the back of this card for a detailed illustration of the following
components:
Multigas Detector Quick Start Card
l
l
l
l
l
l
l
l
l
l
Charge battery until green LED is lit (rechargeable units only).
A flow test must be performed during startup. Block pump inlet when instructed. See
section 3.2.1 of the manual.
To reset alarms press button.
Perform a Bump Test / Calibration Check daily for each installed sensor per section
3.7 of the manual.
button
To activate the InstantAlert feature, press and hold button.
lTurn the instrument ON with the button. Instrument performs a self test and
sensor warm up, then displays sensor information & set points.
Fresh Air Setup: press ‘YES’ or ‘NO’ buttons.
To page through the screens, use the button from the Normal
Operation screen; follow display instructions and press corresponding buttons to
advance to next page.
To Calibrate: ensure you are in fresh air and press and hold the
button and follow instructions on the screen. See section 3.8 of the manual for
complete calibration instructions.
To activate / deactivate MotionAlert feature, use the until MotionAlert
screen appears, and follow display instructions.
Turn the instrument OFF by holding the button.
TM
TM
WARNING
This quick start card provides only a brief description of the operating
instructions for the ALTAIR 5 and ALTAIR 5X Multigas Detector. The
user of this instrument must be fully aware of the limitations and
instructions supplied in the operating instruction manual. Failure to
follow the instructions may lead to serious personal injury or death.
1Button 2 Button 3 Button
CRANBERRY TWP., PENNSYLVANIA, U.S.A. 16066
Note: MSALINK USERS VISIT WWW.MSANORTHAMERICA.COM FOR LATEST
VERSION OR CONTACT CUSTOMER SERVICE FORASSISTANCE

1
3
2
CAL
Quick Start Card
For models: Altair 5, Altair 5X
®®