mxr M116 Fullbore Metal User manual

92503008180revC
M116 FULLBORE METAL

M116 FULLBORE METAL DIRECTIONS
• Run a cable from your guitar to
the Fullbore Metal’s INPUT jack
and run another cable from the
Fullbore Metal’s OUTPUT jack to
your amplier.
• NOTE: Start with Volume, Gain,
and Bass at their lowest setting
(fully counterclockwise). This
pedal is very dynamic and adds
tons of gain—be warned!
• Turn the effect on by depressing
the footswitch.
• Adjust the Gain, Volume, Low,
Mid, Freq and High controls
until the desired output and
tone is acquired.
• Depress the SCOOP button (red
LED lit) for a scooped nu-metal
sound that accentuates the low
and high frequencies.
• To sharpen the attack of
syncopated rhythms or to
cut down on excess noise,
depress the GATE button
(green LED lit). To adjust the
GATE control’s sensitivity,
please refer to diagram A.
7
8
9
CONTROLS
VOLUME knob controls overall
effect volume
FREQ knob selects the
midrange frequency (200Hz to
5KHz) that is adjusted by the
MID control
GAIN knob controls the overall
amount of distortion
GATE button activates the
noise gate
SCOOP button boosts highs
and lows (EQ still functional)
LOW knob controls the
amount of low end
MID knob controls the amount
of midrange selected by the
FREQ control
7
1
2
3
4
5
8
9
SAMPLE SETTINGS
NITEY NIGHT,
SLEEP TIGHT
TUNED DOWN
DOOM
GNU METAL
DESCRIPTION
• Super high gain distortion
• Three band EQ with sweepable
mid frequencies
• Switchable Noise Gate
for syncopated metal riffage
SPECIFICATIONS
Input Impedance >450 kΩ
Output Impedance <10 kΩ
Noise Floor*
Gate OFF -70 dBV
Gate ON -85 dBV
Frequency Response
Gate OPEN 0 dB, 20 Hz to 20 kHz
Gate CLOSED -20 dB at 500 Hz
-25 dB at 20 kHz
Tone Controls
Low ±9 dB at 100 Hz
Mid ±16 dB at 200 Hz to 5 kHz
High ±12 dB shelf at 1.5 kHz
Bypass True Hardwire
Current Draw 18 mA
Power Requirement 9 volts DC
*All controls at mid postion, A-weighted.
POWER
The MXR Fullbore Metal can be
powered by one 9-volt battery
(accessed by removing the bottom
plate of the pedal), a 9-volt AC
adapter such as the Dunlop
ECB003/ECB003E, or a DC Brick™
power supply.
• Internal GATE TRIGGER control
sets the Noise Gate’s sensitivity
• SCOOP button boosts
highs and lows
HIGH knob controls the
amount of high end
FOOTSWITCH toggles
effect on/bypass (blue
LED indicates on)
.
-+
TRIGGER
-+
TRIGGER
DIAGRAM A
INTERIOR VIEW
NOISE GATE TRIGGER CONTROL
With a small athead screwdriver,
rotate the Arrow clockwise to
increase the Noise Gate’s sensitivity,
causing the gate to cut off faster.
Rotate the Arrow counter-clockwise
if notes are being cut off too early.
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: [phone] FAX: [phone]