mxr M299 User manual

Carbon Copy
Mini Analog Delay
This pedal packs the organic analog warmth and
ease of use of the original Carbon Copy Analog
Delay into an MXR mini housing with added sonic
versatility so that you can make the most out of
your pedalboard real estate.
M299
jimdunlop.com/m299
®

M299 | Carbon Copy®Mini Analog Delay 2
1MOD switch toggles modulation on/off (orange LED indicates on)
2REGEN knob sets number of repeats
3MIX knob controls blend of wet and dry signals
4DELAY knob sets time between repeats
5FOOTSWITCH toggles effect on/bypass (blue LED indicates on)
6 BRIGHT switch accentuates delay signal's high end frequencies (blue LED indicates on)
1
24
3
5
External Controls
6

M299 | Carbon Copy®Mini Analog Delay 3
Basic Operation
1 Run a cable from your guitar to M299’s INPUT jack and another
cable from M299’s OUTPUT jack to your amplifier.
2Start with all knobs set to 12 o’clock.
3 Turn effect on by depressing the footswitch.
4Rotate REGEN knob clockwise to increase number of repeats or
counterclockwise to decrease it.
5Rotate MIX knob clockwise to increase ratio of wet to dry signal
or counterclockwise to decrease it. Fully clockwise results in
half wet/half dry mix while fully counterclockwise results in
100% dry signal.
6 Rotate DELAY knob clockwise to increase delay time or
counterclockwise to decrease it.
7 Use a jeweler’s flathead screwdriver to flip the BRIGHT switch
toward heel of pedal to accentuate delay signal’s high end
frequencies (indicated by blue LED).
8Push in MOD switch to add modulation to your delay signal.
Modulation width and speed can be adjusted internally (remove
bottom plate) with a 3mm slotted screwdriver (see Diagram A).
The Carbon Copy®Mini Analog Delay is powered by the
Dunlop ECB003 9-volt adapter or the DC Brick™ , Iso-Brick™ ,
and Mini Iso-Brick™power supplies. This pedal cannot be
powered by a battery.
Power
Directions
DIAGRAM A

M299 | Carbon Copy®Mini Analog Delay 4
Specifications
*Regen at max CCW, A-weighted
Input Impedance 1MΩ
Output Impedance 1kΩ
Max Input Level +5 dBV, 500 Hz
Max Output Level +8 dBV
Noise Floor**
Mix at Max CW -96 dBV
Mix at Max CCW -104 dBV
Delay Distortion <1%, 1 kHz -5 dBV Input
Delay Time 20 ms to 600 ms
Noise Reduction 2:1 ratio
Modulation Speed 0.2 Hz to 2.2 Hz
Bypass True Hardwire
Current Draw 26 mA
Power Supply 9 volts DC