mxr Third Man Hardware Double Down User manual

MXR x Third Man Hardware
Double Down Pedal
MXR and Third Man Hardware have teamed up to
create the perfect booster for gigging guitar players.
The Double Down Pedal combines two separate MXR
Micro Amp circuits into a single box so that you can
dial in just the right amount of classic Micro Amp
bump for both of your signal chains.
CSP042
jimdunlop.com
™
®

CSP042 | MXR®x Third Man Hardware Double Down™Pedal 2
1FOOTSWITCH toggles effect on/bypass (yellow LED indicates on)
2GAIN 1 knob sets output level of OUT 1 signal
3GAIN 2 knob sets output level of OUT 2 signal
4PHASE switch selects stereophonic effect (yellow LED indicates on)
5BUFFER switch selects true/buffered bypass (yellow-orange LED indicates buffered bypass)
2
External Controls
1 5
4
3

CSP042 | MXR®x Third Man Hardware Double Down™Pedal 3
Basic Operation
1. Run an instrument cable from your instrument to the
CSP042’s INPUT jack. Run two more instrument cables
from the CSP042’s OUT 1 and OUT 2 jacks to two
separate amplifiers.
2. Start with knobs set fully counterclockwise.
3. Turn effect on by depressing the footswitch.
4. Rotate GAIN 1 knob clockwise to boost OUTPUT 1
signal up to +26db.
5. Rotate GAIN 2 knob clockwise to boost OUTPUT2
signal up to +26db.
6. Move PHASE switch to its RIGHT position (towards
output jacks) for a pronounced stereophonic effect when
using both output jacks, indicated by yellow LED.
7. Move BUFFER switch to its RIGHT position (away
from input jack) for true bypass switching or to its
LEFT position (towards input jack) for buffered bypass
switching, indicated by yellow-orange LED.
The MXR®x Third Man Hardware Double Down™Pedal
is powered by one 9-volt battery (remove bottom plate to
install), a 9-volt AC adapter such as the Dunlop ECB003/
ECB003EU, or an MXR®Brick™Series power supply.
Power Directions

CSP042 | MXR®x Third Man Hardware Double Down™Pedal 4
Specifications
Input Impedance
Buffer OFF > 450 kΩ
Buffer ON > 700 kΩ
Output Impedance < 1 kΩ
Bypass Buffered/True Bypass
Current Draw 11 mA
Power Supply 9 volts DC