Nags Head Hammocks Cumaru Deluxe Double Porch Swing User manual

ORIGINAL CUMARU DELUXE
DOUBLE PORCH SWING
INSTRUCTIONS
• LEFT ARM
• RIGHT ARM
• CENTER TABLE SUPPORT
• TABLE
• (2) OUTSIDE VERTICALS
• MIDDLE VERTICAL
• UPPER SEAT
• UPPER SUPPORT
• LOWER SUPPORT
• LOWER ROPE
SEAT SUPPORT
1. HEX BOLTS: (1) 2.25”; (2) 2.5”; (2) 3.5”
2. HEX LAGS: (3) 2.5”
3. BARREL BOLTS: (4) 2.5”
4. BARREL NUTS: (5) 3/4”
• CHAIN SETS: (2)
NOTE: Not to scale.
Nuts and washers attached
Back view of swing and chains
5. WASHERS: (12) 1/4”
6. LOCK NUTS: (4) 1/4”
7. TREE HOOKS: (2) (not shown)
8. HEX KEY: (1) (not shown)
HARDWARE PACK
CHAIR PARTS
CHAIN SET
LONG
CHAIN
FRONT
MEDIUM
CHAIN
SHORT
CHAIN
3.5” EYE
BOLT
3.5” EYE
BOLT
2.5” EYE
BOLT
• MALLET
• 7/16” WRENCH
• 1/2” WRENCH
• FLAT HEAD SCREWDRIVER
SUGGESTED TOOLS
1a.
1a.
1b.
1b.
1c.
2.
3.
4.
5.
6.
1c.

ASSEMBLY
STEP 4. Remove table.
Use 2.25” hex bolt,
washer, and bolt nut to
attach lower rope seat
support to center table
support. Replace table
and tighten all bolts.
STEP 3. Use (3) 2.5”
barrel bolts and (3)
barrel nuts to attach
upper support to
verticals. (Rope not
pictured)
BARREL NUT
2.5” HEX
BOLT
OUTSIDE
VERTICAL
MIDDLE
VERTICAL
TABLE
OUTSIDE
VERTICAL
2.5” EYE BOLT
2.5” EYE
BOLT
2.5” HEX
BOLT
3.5” HEX
BOLT
LOCK
NUT
WASHER
BARREL
NUT
LOWER
ROPE SEAT
SUPPORT
STEP 1. Use (3) 2.5” lag bolts
and (3) washers to attach
left arm, right arm, and center
table support to lower support.
STEP 2. Use (4) 2.5” hex bolts,
(8) washers, and (4) lock nuts
to attach (2) outside verticals
to left and right arms.
Use (2) 3.5” hex bolts, (4)
washers, and (2) lock nuts
to attach table and middle
vertical to center table support.
NOTE. do not tighten bolts
until Step 4.
WASHER
2.5” LAG
BOLT
LOWER
SUPPORT
LEFT
ARM
CENTER TABLE
SUPPORT
RIGHT
ARM
2.5” BARREL BOLT
UPPER
SUPPORT 2.25”
HEX BOLT
WASHER

Congratulations on purchasing this Original Cumaru Rope Porch Swing.
QUESTIONS REGARDING THIS PRODUCT? Call our customer service team,
1-800-344-6433.
INSTALLATION - Install the ceiling hooks in the overhead support. The hooks should
be approximately 5 feet apart. The supports can be ceiling joists, a sturdy limb, or
a beam installed for the swing. A ready made stand or instructions to build one are
available, please inquire. If the ceiling joists are not exposed, locate one using a stud
finder. They are usually 16 to 25 inches apart. Once you find a suitable support, drill
a 3/16” starter hole to screw the ceiling hooks into and tighten until the shank is no
longer visible. Do not adjust the chains as they are properly connected and able
to withstand approximately 500 lbs. of weight. We have replacement chain sets
available for sale if needed.
MAINTENANCE - Sunwax Penetrating Wood FeederTM is recommended as an
added protection for wood from insects and weather. It is ideal for cumaru,
revitalizes the look of older wood and helps maintain wood’s original hue. To
clean rope use soap, detergent or a mild bleach solution. Use a soft bristled scrub
brush to work on any stains. Be sure to rinse the ropes thoroughly after cleaning.
WARRANTY & RETURNS - Nags Head Hammocks products are guaranteed to
be free of defects in both workmanship and material. Prolonged exposure to
weather conditions including snow, rain, and humidity are not covered under
the warranty, nor is damaged caused by normal wear, mildew, or improper care,
including storage, maintenance, and assembly. If you are not satisfied with an
item, return it unused in its original packaging for a complete refund or exchange.
You can return it to any of our stores or to our warehouse, Nags Head hammocks,
305 Industrial Blvd., Greenville, NC 27834. Please include a copy of your receipt
and your contact information.
ASSEMBLY
5065NH-CM / 0617
STEP 5. Use 2.5” barrel bolt and bolt nut to attach upper
rope seat outside and middle verticals. Use (2) eye bolts,
(4) washers, and (2) nuts to attach shorter end of chain
set to upper seat support. Use (2) eye bolts, (4) washers,
and (2) nuts to attach longer end of chain set to left and
right arms. (Rope not pictured)
NUT
2.5” BARREL
BOLT
2.5” BARREL
NUT
3.5”
EYE BOLT
3.5”
EYE BOLT LONG CHAIN
SHORT
CHAIN
MEDIUM
CHAIN
WASHER