National Instruments PC/104-GPIB User manual

1Insert CD, then choose Install NI-488.2 Software for Windows.
2
(Continued)
Power Off
Computer
Shut down, then power off computer.

3Install hardware*.
Key
1PC/104-GPIB
2GPIB Connection
3GPIB Ribbon Cable
4Screw
5Stand Off
6Parent Module
7PC/104 Connector
8PC/104 Header
* For Help installing your hardware,
refer to the GPIB Hardware Guide
(available on the CD through View
Documentation).
A. Verify that you have the correct PC/104-GPIB stackthrough version: 16-bit modules have two PC/104
connectors; 8-bit modules have one PC/104 connector.
B. Mount the provided standoffs to the parent module. The parent module has either two or four mounting
holes for standoffs.
C. Plug the PC/104-GPIB into the parent module. Ensure proper contact by gently pressing the
PC/104-GPIB connector and PC/104 header together.
D. Use the provided screws to fasten
the PC/104-GPIB to the standoffs.
E. Plug in the GPIB ribbon cable.

4Power on computer, then run NI-488.2 Getting Started Wizard.

© Copyright 1999 National Instruments Corporation. All rights reserved. Product and
company names listed are trademarks or trade names of their respective companies.
www.natinst.com/support/
[email protected]
Tel: [phone] • Fax: [phone]
Fax-on demand: [phone] • ftp.natinst.com
322270A-01 020899