Nauticam 87501 User manual

Current as of 2020-11-02
Instruction Manual for
Flip Holder for EMWL
PN# 87501
FOREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the
requirements of professional as well as amateur underwater
photographers and fulfill them through the innovative designs of our
products. We strive to achieve a high level of user-friendliness by
allowing stress-free installation and easy operation of all important
functions of the camera.
Please read this manual carefully before using the product, this will
maximize its performance as well as its lifetime.
WARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for
consumer use. This warranty only applies to products purchased from
authorized NAUTICAM dealers and does not extend beyond the original
retail purchaser.
To return your product for service, please contact your regional
authorized service center(s). Please note that this warranty only applies
when the product is purchased in the territory where the service center
is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthorized modifications and/or repairs of our products will
automatically invalidate the warranty.
1. Press the lever for diopter holder and open the diopter
holder to the side then remove the locking ring from the flip
holder.
2. Align the two positioning screws on the back of the holder
with the slots on the front of the port.
3. Fasten the holder by screwing the locking ring into the
thread on the front of the port.
IDENTIFICATION OF PART
INSTALL TO THE PORT
Diopter Holder
Release Button
for EMWL
Locking Ring
Lever for Diopter Holder
Base Protector for EMWL
EMWL Focusing Unit Holder
EMWL Relay Lens Holder
Thumb Screw for
Relay Lens Holder

Current as of 2020-11-02
1. Remove a bayonet mounting ring from EMWL focusing unit
by unscrewing 6x thumb screws as shown.
2. Open the relay lens holder by unscrewing the thumb
screw.
3. Mount the EMWL focusing unit on the EMWL holder as
shown.
4. Secure the EMWL on the flip holder by tightening 6x
thumb screws.
5. Close the relay lens holder and securely tighten with
the thumb screw.
SPECIFICATIONS
Weight
(air/underwater):
600g / 400g
Compatible ports:
18702 Macro port 87
18703 Macro port 94
37126 N100 Macro port 105
18708 N120 Macro Port 80
Remark: Nauticam supports only e-manuals. Please download corresponding
product manuals on Nauticam.com website, or contact us for e-manuals.
MOUNT EMWL ON THE FLIP HOLDER